Apogee JAM Quick Start Manual

QuickStart Guide

Plug JAM into your iPad using the provided iPad dock cable

Plug your guitar into JAM’s 1/4” input

Plug your headphones into iPad’s headphone output or just listen through iPad’s built-in speakers

Click the Record button and you are recording with JAM!

Using JAM with an iPad

Start up GarageBand and choose New Song
(JAM’s status light should turn to green)

Choose Guitar Amp

To hear your track, turn Monitor ON by clicking and following instructions

Check the status light on JAM, it should be Blue

Blue - JAM is connected but not ready

Green - JAM is connected, ready and

working with your software
Red - Your gain is too high, adjust

the gain using the Gain Control Knob

on the side of JAM

Plug JAM into your Mac using the provided USB cable

Plug your guitar into JAM’s 1/4” input

Start up GarageBand, Choose New Project > Electric Guitar
(JAM’s status light should turn to green)

Name the Project and save it on your hard drive

Go to GarageBand > Preferences > Audio/Midi >

Choose JAM for Audio Input
Choose Built-In Output for Audio Output

Plug your headphones into your Mac’s headphone
output or just listen through your Mac’s built-in speakers

To hear your track in GarageBand, click to turn monitoring on

Click the Record button and you are recording with JAM!

Using JAM with a Mac

Check the status light on JAM, it should be Blue

Blue - JAM is connected but not ready

Green - JAM is connected, ready and

working with your software
Red - Your gain is too high, adjust

the gain using the Gain Control Knob
on the side of JAM

For FAQs and more JAM support information,

please visit the Apogee Website:

http://support.apogeedigital.com/

Apogee Electronics Corporation

1715 Berkeley St.

Santa Monica, CA 90404 U.S.A.

00+1 310-584-9394