Page 1
This quick installation guide was designed to help with the basic configuration for
the Raptor ATX. More detailed information can be found in the installation guide.
Processor Installation:: When installing the processor, make sure to select the
correct setting for the BUS clock through jumper JP11. Incorrect BUS clock
selection can cause damage to the CPU and void the product warranty.
Page 2
To install the processor follow these
steps:
Lift the lever of the PGA socket
and gently insert the processor.
Make sure the diagonal notch on
the processor matches the notch
on the socket. This notch
represents pin 1.
1.
Make sure the processor is
inserted all the way.
2.
Lower lever.3.
Memory Configuration: The Raptor ATX features three memory banks (3
DIMM sockets) allowing up to 384MB of unbuffered SDRAM or up to 768MB of
registered SDRAM with ECC support.
Jumper Selection Table
Jumper Description Manufacturer's Settings
Jumper
Position
JP2 Flash BIOS Selection Write Protected 1-2
JP4 Power-On Selection Power-On Immediately 1-2
JP5 CMOS REST Normal 1-2
JP6
Watchdog Timer I/O
Address
110 1-2
JP7
Disk-On-Chip
Address Selection
D000/D400 1-2
JP8
Watchdog Timer
Time-Out
1200ms 1-2
JP10
Watchdog Timer
HDW/SFW Selection
Disabled 3-4
JP11 BUS Clock Selection Auto 1-2
JP12 Ethernet Selection Enable 1-2
Processor BUS Frequency Table
BUS Speed Auto 66 MHz 100 MHz
JP11
1-2 2-3 3-4
Page 3
CPU Support
PGA370 socket architecture supports Intel Pentium® Celeron®
processors up to 466MHz
●
Bus Clocks
66 and 100MHz supported
●
Memory
Three banks (3 sockets) DIMM up to 384MB SDRAM or up to 768MB
registered SDRAM, ECC supported
●
Ethernet
On-board 10 Base-T/200Mbits (Intel 82559ER)
●
On-Board I/O
Two floppies with 2.88 MB
●
Two high speed RS-232 serial ports 16Bytes FIFO (16550)●
One parallel port (bi-directional, ECP/EPP compatible)●
One PS/2 mouse connector and one PS/2 keyboard connector●
Two Universal Serial Bus connectors●
One AGP, four PCI and three ISA slots●
Dual-channel PCI 32-bit EIDE controller●
RJ34 ethernet connector●
ULTRA-DMA up to 33MB/sec. supported●
LS120 drive supported●
On-Board Flash Disk (optional)
On-board two single-chip flash disk device in a standard 32-pin DIP
socket up to 288MB of capacity with high-speed boot-up capabilites
●
On-Board Industiral Device (optional)
Post (Power-On-Self-Test) code display
●
Hardware/software watchdog Timer●
ROM BIOS
Page 4
AMI© HIFLEXTM BIOS●
Loading...