A.O. Smith BTP-139A User Manual

AA Smith

Commercial Gas Water Heaters

Conservationist• *

LIGHT-DUTY. POWERED DURDER

These small-volume Conservationist® BTP models are equipped with powered gas,

non-forced-draft burners requiring a negative draft. With 75- and 86-gallon storage capacities and inputs from 140,000 to as high as 370,000 BTUs, they are suitable for light- to mediumdemand commercial applications.

POWERED GAS BURNER

• Electronic flame safeguard control with direct spark ignition

• Redundant gas valves for added safety

• Power gas burner requires 120V, 60Hz service

• Non-forced-draft burner; negative draft required in vent piping

FULLY AUTOMATIC CONTROLS WITH SAFETY SHUTOFF

• High temperature limit control (manual reset)

• Dual thermostats for accurate temperature control 120°F - 180°F

PERMAGLAS® ULTRA COAT^ GLASS LINING

• Exclusive process provides superior protection against corrosion

• CoreGard™ anode rods with stainless steel core provide additional corrosion protection

BAROMETRIC DRAFT DAMPER

• Ensures proper draft for maximum efficiency

HANDHOLE CLEANOUT

• Allows easy access to tank interior for cleaning

FACTORY-INSTALLED TEMPERATURE AND PRESSURE RELIEF VALVE

80% THERMAL EFFICIENCY

MAXIMUM HYDROSTATIC WORKING PRESSURE: 160 PSI PROFESSIONAL START-UP SERVICE

• Assures most efficient combustion and safe initial installation

FLAME INSPECTION PORT OPENING MOUNTED ON RUGGED CHANNEL IRON SKIDS MUST BE INSTALLED ON NON-COMBUSTIBLE SURFACE

CODES AND STANDARDS

• Design-certified by UL (Underwriters Laboratories) International, according to ANSZ21.10.3-CSA4.3 standards governing storage-type water heaters

• Meets ASHRAE/IESNA 90.1-1999

• Meets CEC and New York Codes for thermal efficiency and standby loss

THREE-YEAR LIMITED TANK WARRANTY

• For complete information, consult written warranty or contact A. O. Smith

OPTIONS

□ ASME tank construction □ National Board Registration on ASME models □ Illinois School Code on BTP-199, BTP-370 □ Low-water cutoff □ 5-year or 10-year extended limited warranty

BTP-139/A

th r o u o h

BTP-370/A

A.O.Smith

Water Heaters

July2007R

A.CXSmith

Conservatioiiisf

LIGHT-DUTY, POWERED BURNER

CAPACITY, INPUT AND OUTPUT

MODEL

NUMBER

BTP-139/A 140,000 BTP-199/A BTP-270/A 270,000 BTP-370/A

BTU

INPUT

PER

HOUR

199,000

370,000

Gallons

Litres

U.S. Gallons 81 0 GPH 0 136 97

Litres 306.6 0.0

U.S. Gallons 81 0

Litres 306.6 0.0 LPH 0.0 730.4 521.7

U.S. Gallons 81 0 GPH 0 262 187

Litres 306.6 0.0

U.S. Gallons 81 0

Litres 306.6 0.0 LPH 0.0 1358 970

TANK

SIZE

FIRST HOUR

RATING

100°F

RISE

Commercial Gas Water Heaters

GPH

LPH

LPH GPH

RECOVERY-GALLONS

PER HOUR AT °F

TEMPERATURE RISE

40°F 100°F 140°F 22°C 56°C 78°C

0.0 514.8 0 193 138

0.0 991 707.8 0 359 256

367.1

MAXIMUM AMPERES

120 V, 60

Hz,1

5 5 5

DIMENSIONS AND SHIPPING WEIGHTS

MODEL

NUMBER

BTP-139/A

BTP-199/A BTP-270/A

BTP-370/A

’Natural & Propane (LP)

(Natural or Propane) gas water heater(s) shall be A. O. Smith Conservationist® Model BTP gallons, an Input rating of hydrostatic working pressure of 160 PSI. Heater(s) shall meet ASHRAE/IESNA 90.1 -1999 for thermal efficiency and standby loss. Water heater(s) shall have glass-lined tank, protected against elctrolytic corrosion by multiple factory-installed anode rods. Other standard equipment shall Include: 1) Powered gas burner with redundant main gas valves, electronic Ignition, automatic pilot gas valves, gas pressure regulator, and flame Inspection port: 2) Handhole cleanout: 3) High temperature limit control: 4) Dual thermostat for accurate temperature control; 5) Factory-Installed T&P valve. Controls shall Include a Fenwal OSI to provide direct spark Ignition and flame monitoring. A prepurge of 30 seconds minimum shall be provided. A trial for Ignition period of 5 seconds, after which If the flame Is not proved or lost during the running cycle, the system will lock out. Heater(s) tank shall have a 3-year (or extended 5- or 10-year limited) warranty against corrosion as outlined In the warranty.

Inches

Inches 74.75 65

Inches

CM 189.9 165.1 67.9 15.2 54.3 70.5 96.5 216.5 1.3 247.7 Kg 288.6 Kg 3.8 3.8

Inches 74-3/4 65 26-3/4 6 21-3/8 27-3/4 38 85-1/4 3/4 547 Lbs. 632 Lbs. 1-1/2 1-1/2

Inches

A B

189.9 165.1 67.9

74-3/4

189.9 165.1 67.9

74-3/4

189.9 165.1 67.9

_____

26-3/4

BTUs per hour, a recovery capacity of

DIMENSIONS SHIPPING WEIGHT 0 E 6 21-3/8

15.2 6 21-3/8

15.2

27-3/4

54.3 70.5 96.5 216.5 1.3 27-3/4

54.3 70.5 96.5 216.5 1.9 248.6 Kg 287.3 Kg 3.8 3.8 27-3/4

54.3 70.5 96.5 216.5 1.9 248.6 Kg 287.3 Kg 3.8 3.8

SUGGESTED SPECIFICATION

_____

J GAS

85.-1/4 1/2

85-1/4 1/2

85-1/4 3/4

GPH at 100°F temperature rise and a maximum

STANDARD ASME IN OUT

556 Lbs. 658 Lbs.

252.7 Kg 545 Lbs. 635 Lbs.

547 Lbs. 632 Lbs.

____

with a storage capacity of

299.1 Kg 3.8 3.8

1-1/2 1-1/2

________

A.O:Smith

Water Heaters

www.hotwater.com

500 Tennessee Waltz Parkway, Ashland City, TN 37015

For Technical Information and Automated Fax Service, call 800-527-1953.

A. 0. Smith reserves the right to make product changes or improvements without prior notice.

ACGSS01305