Antunes DC-14 User Manual

BAKERY DISPLAY CABINETS

A.J. Antunes & Co.

DC-14 AND DC-22

MFG. NOS. 9500719, 9500718

Place this manual in the Toaster section

of your Equipment Manual.

Manufactured exclusively for

McDONALD’S®

BY

ANTUNES

180 KEHOE BLVD.

CAROL STREAM, ILLINOIS 60188, U.S.A.

PHONE: [phone]

TOLL FREE: [phone]

FAX: [phone]

www.antunes.com

TABLE OF CONTENTS

Owner Information .....................................................2

General ......................................................................2

Service/Technical Assistance ....................................2

Warranty Information .................................................2

Specifications .............................................................3

Scan with mobile device or enter URL

for product and service information.

DC-14 AND DC-22 DISPLAY CASES

Display Case

http://tiny.cc/aja-DC

Installation ...................................................................4

Unpacking ..................................................................4

Installing the Shelves (model DC-14) ........................4

Installing the Shelves (model DC-22) ........................4

Location .....................................................................4

Daily Cleaning .............................................................5

DC-14 Replacement Parts..........................................6

DC-22 Replacement Parts..........................................7

Wiring Diagram ...........................................................8

Notes............................................................................9

The Antunes Food Service Equipment Division of A.J. Antunes & Co. provides the following limited warranty to the original purchaser of all McDonald’s Equipment.
All components are warranted against defects in the material and workmanship for a period of two (2) years from date of original installation.

If any part becomes defective during the period of this Warranty, Antunes Food Service will pay labor costs to an Authorized Service Agent to replace the part plus
travel expenses.

WARRANTY EXCLUSIONS

• The cost of Installation.

• Equipment that has been damaged due to shipment. Purchaser should
make damage claim directly upon carrier.

• Alteration, misuse, abuse.

• Improper storage or handling.

• Improper maintenance.

• Failure to follow proper Installation instructions, including electrical
connection.

Antunes Food Service reserves the right to make changes in design or add improvements on any products. The right is always reserved to modify Equipment
because of factors beyond our control and government regulation. Changes to Equipment do not constitute a warranty charge.
This warranty is exclusive and is in lieu of all other warranties, expressed or implied, including any implied warranty of merchantability or fitness for a particular
purpose, each of which is expressly disclaimed. The remedies described above are exclusive, and in no event shall A.J. Antunes & Co. or any of its Divisions be
liable for special consequential or incidental damages for the breach or delay in the performance of this warranty.

P/N 1012031 Rev. D 05/18
McDonald’s

LIMITED WARRANTY

• Improper or unauthorized repairs.

• Scheduled Maintenance procedures as outlined in your MRC Card.

• This Warranty does not cover Consumable items.

• Water pressure problems or contamination problems such as foreign material
in water lines or inside solenoid valves due to an incoming water source.

• Freight, foreign, excise, municipal or other sales or use taxes.

• Consequential damages such as loss of profit, loss of time, the cost of repair­ing or replacing other property which is damaged, or any other incidental
damage of any kind.

This manual is for the exclusive use of licensees and employees of McDonald’s Systems, Inc..

© McDonald’s Corporation All Rights Reserved

1

DC-14 AND DC-22 DISPLAY CASES

OWNER INFORMATION

General

Read this manual before installing or operating the dis­play case. It provides the necessary safety, installation,
and operating procedures.

This dsiplay case is manufactured from the finest mate­rials available and assembled to our strict quality stan­dards. This unit has been tested at the factory to ensure
dependable, trouble-free operation.

Service/Technical Assistance

If you experience any problems with the installation
or operation of your unit, contact Antunes Technical
Service at [phone] (toll free).

Warranty Information

Please read the full text of the Limited Warranty in this
manual.

If the unit arrives damaged, contact the carrier imme­diately and file a damage claim with them. Save all
packing materials when filing a claim. Freight damage
claims are the responsibility of the purchaser and are
not covered under warranty.

The warranty does NOT extend to:

Fill in the information below and have it handy when
calling Antunes Technical Service for assistance. The
serial number is on the specification plate located on
the rear of the unit.

Purchased From:

Date of Purchase:

Model No.:

Serial No.:

Mfg. No.:

Use only genuine Antunes replacement parts in this
unit. Use of replacement parts other than those sup­plied by the manufacturer will void the warranty.

• Damages caused in shipment or damage as result
of improper use.

• Installation of electrical service.

• Normal maintenance as outlined in this manual.

• Malfunction resulting from improper maintenance.

• Damage caused by abuse or careless handling.

• Damage from moisture into electrical components.

• Damage from tampering with, removal of, or
changing any preset control or safety device.

IMPORTANT! Keep these instructions for future reference. If the unit

changes ownership, be sure this manual accompanies the equipment.

2

P/N 1012031 Rev D 05/18

McDonald’s

DC-14 AND DC-22 DISPLAY CASES

SPECIFICATIONS

DC-14 DC-22

A

Model

No.

DC-14 9500719

DC-22 9500718

Mfg. No.

Height

(A)

28”

(711.2 mm)

28”

(711.2 mm)

C

B

A

Dimensions Electrical Specifications

Width

(B)

14”

(355.6 mm)

22”

(558.8 mm)

Depth

(C)

22”

(558.8 mm)

22”

(558.8 mm)

Volts Watts Hertz Plug

120 20

50/60 NEMA 5-15 P

120 40

C

B

P/N 1012031 Rev. D 05/18
McDonald’s

3

DC-14 AND DC-22 DISPLAY CASES

INSTALLATION

Unpacking

The large box contains:

z The display case

z Two shelves (DC-14)

Four shelf pieces, two front and two rear (DC-22)

z The owner’s manual

2. Remove the foam inserts from the box.

3. Carefully remove the display case.

4. Unpack the shelves.

NOTE: If any parts are missing or damaged, con­tact Antunes Customer Service IMMEDIATELY at
[phone] (toll free).

4. Perform the daily cleaning steps found in publica­tion PR 80, Bakery Cases (P/N 1012042).

Installing the Shelves (model DC-14)

1. Gently slide one shelf into the bottom shelf sup­port. The lip at the front edge of the shelf will
extend over the shelf support. (The shelf support
will not be visible when viewed from the front of
the cabinet.)

2. Repeat for the upper shelf.

Location

When placing the display case into service, observe
these guidelines:

• Do NOT block or cover any openings on the unit.

• Keep away from heated surfaces.

1. Place the display case in the position designated
by McDonald’s.

2. Load product into the display case.

3. Insert the appropriate card into the display card
holder.

4. Connect the power supply to an appropriate outlet.

5. To turn on the display case lights, press the rocker
switch to the on position.

Installing the Shelves (model DC-22)

1. Gently slide one shelf front into the bottom shelf
support. The lip at the front edge will extend over
the shelf support. (The shelf support will not be
visible when viewed from the front of the cabinet.)

2. Gently slide the rear half of the shelf into the shelf
support until it rests snugly against the shelf front.

3. Repeat for the upper shelf.

4

P/N 1012031 Rev D 05/18

McDonald’s

DAILY CLEANING

1. Remove all food from the cabinet.

2. Remove the food trays and product label tags and
take them to the back sink. Remove the holding
time labels from the food trays before cleaning.

3. Wash, rinse, and sanitize the trays and label tags in
the three-compartment sink or Warewash machine.
Allow them to air dry.

4. Wipe and discard crumbs from inside the cabinet
with a clean, sanitizer-soaked towel. Discard the
towel in the soiled towel bucket after use.

5. Remove the shelves.

6. Spray a clean paper towel with one or two sprays of
KAY Peroxide Multi-Surface Cleaner & Disinfectant
Solution. Wipe the glass, cabinet door, and door
knobs until completely dry. Repeat until all glass
areas (exterior and interior) are clean. Discard the
paper towels in a trash receptacle.

7. Wash the shelving in the 3-compartment sink with
KAY® All Purpose Super Concentrate Solution and
a clean, sanitizer-soaked towel. Discard the towel
in the soiled towel bucket immediately after use. If
necessary, use a KAY® NO-SCRATCH™ Pad to
remove hardened soils.

DC-14 AND DC-22 DISPLAY CASES

Caution

Do not use an abrasive pad on the shelves. It will
scratch and dull the surfaces.

8. Rinse the shelves with water then sanitize them
with KAY® SolidSense Sanitizer for 1 minute.

9. Remove the shelves from the sanitizer solution and
allow them to air dry. Discard the towel in the soiled
towel bucket immediately after use.

10. Replace the shelves in the cabinet.

11. Replace the food trays.

P/N 1012031 Rev. D 05/18
McDonald’s

5

DC-14 AND DC-22 DISPLAY CASES

DC-14 REPLACEMENT PARTS

Item Part No. Description Qty.

1 7001876 Top glass kit 1
2 0024066 Top glass support 1
3 0024127 Support, inner BKT-LH 1
4 7001884 Light assembly kit 3
5 325P193* Screw, hex head, 1/4-20 x 1.375” 12
6 7001881 Top shelf kit 1
7 7001878 Side glass kit 2
8 0024012 Tube, Support LH 3
9 0024064 Support, shelf lower 1
10 7001882 Bottom shelf kit 1
11 7001580 Power switch kit 1
12 0024065 Suppport, shelf upper 1
13 2110150 Magnet, snap-in 9/16 1

1

26

2

to

3

24

25

23

Item Part No. Description Qty.

14 7001883 Door kit 1
15 0024078 Support, outer BKT-RH 1
16 0024011 Tube, support RH 3
17 7001880 Power supply kit 1
18 0508891 Base cover 1

19 308P157* Screw, tap 8-32 x 3/8” LG 8
20 0024063 Base weldment 1
21 7001877 Front glass kit 1

22 7001879 Corner bracket kit 2
23 310P162* Screw, mach. #10-24 x 3/8” 8
24 7001885 Left door hinge kit 2
25 308P157* Screw, tap 8-32 x 3/8” LG 4
26 0508515 Hinge plate 2

* Available in packages of ten

1

7

3

5

4

6

22

14

15

13

5

12

11

16

17

7

18

19

4

10

9

4

20

8

21

6

P/N 1012031 Rev D 05/18

McDonald’s

DC-14 AND DC-22 DISPLAY CASES

DC-22 REPLACEMENT PARTS

Item Part No. Description Qty.

1 0024077 Support, outer BKT-LH 1

2 325P193* Screw, hex head, 1/4-20 X 1.375” 12
3 0024012 Tube, Support LH 3
4 7001878 Side glass kit 1
5 0024943 Top glass support 1
6 7001879 Corner bracket kit 2

7 7001886 Top glass kit 1
8 7001887 Front glass kit 1
9 7001891 Light assembly kit 3
10 7001890 Front shelf kit 2
11 7001888 Top shelf rear kit 2
12 7001889 Bottom shelf rear kit 1
13 0024038 Upper shelf support 1

14 0024026 Lower shelf support 1
15 0024079 Support, outer BKT-RH 1

26

25

5

27

28

Item Part No. Description Qty.

16 0024011 Tube, Support RH 3
17 0024010 Main housing 1
18 7001885 Left door hinge kit 2
19 7001892 Left door kit 1
20 7001893 Right door kit 1
21 7001580 Power switch kit 1
22 7001880 Power supply kit 1

23 0700463 Power cord, 14/3 5-15P 1
24 0400251 Strain relief, cord con 1
25 7001896 Right door hinge kit 2
26 310P162* Screw, mach. #10-24 X 3/8” 16
27 308P157* Screw, tap 8-32 X 3/8” LG 8
28 0508515 Hinge plate 4

* Available in packages of ten

7

6

9

18

4

3

10

11

8

2

10

12

1

3

3

9

13

9

16

2

17

14

16

19

20

16

4

15

P/N 1012031 Rev. D 05/18
McDonald’s

21

22

23

24

7

DC-14 AND DC-22 DISPLAY CASES

WIRING DIAGRAM

8

P/N 1012031 Rev D 05/18

McDonald’s

DC-14 AND DC-22 DISPLAY CASES

NOTES

P/N 1012031 Rev. D 05/18
McDonald’s

9

[phone]

[phone]

[phone]

[phone]

[phone]