®
Weight (kg)
Description – Colossus LED High Output Floodlight
Installation Instructions
Luminaire Code(s) – ACOLOED
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
General Installation Instructions
These instructions should be read carefully prior to any installation and retained after completion for further
reference and maintenance. Please give these instructions to the building owner/occupier after installation.
Important Safety
1. Before installation, maintenance or lamp replacement, ensure that the mains supply to the luminaire is switched off and the
circuit supply fuses are removed or the circuit breaker is turned off.
2. It is recommended that only a qualified electrical contractor carries out the installation of this luminaire and that the
luminaire is installed in compliance with the current edition of the IEE Wiring Regulations.
3. The per
does not exceed the rating of the circuit cable, fuse or circuit breaker.
4. Where a luminaire incorporates discharge control gear (inductive load), the circuit capacity and ratings require careful
sizing to avoid nuisance tripping of the protective device used in the installation.
5. Where applicable, careful consi
of a suitable size for the luminaire being installed.
Ratings
1. All luminaires are manufactured & tested in compliance with the requirement contained within BS EN 60598 and are CE marked.
2. All luminaires that are of Class 1 construction and that are marked accordingly, MUST be earthed.
3. All luminaires are designed to operate at 230Volts AC -6% / +10% = 216Volts to 253Volts. Do not operate outside these voltages.
4. All luminaires are only suitable for applications within their rated Ingress Pr
5. Ambient temperature -40 - 50°C
Model L L1 L2 W H H1
son carrying out the installation is to check and verify that the total load on the circuit, including that of this luminaire
deration should be taken during installation to ensure that all fixings and/or suspensions are
otection limits as stated.
ACOLOED500 368 410 450 603 194 118 16.9
ACOLOED1000 655 702 739 603 194 118 32
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------Page No. 1 Issue 1.0 www.anselluk.com
®
Installation
Please note – terminal block not included.
This luminaire contains no serviceable or replaceable parts.
The external flexible cable or cord of this luminaire cannot be replaced, if the cord is damaged the luminaire shall be
replaced.
If the glass becomes cracked or broken please ensure that the luminaire is replaced.
The fitting is suitable for fixing to the wall and to the ceiling.
Please observe the minimum mounting distance of 5 metres from surfaces b
The fitting has an earthing connection. The earth wire (green/yellow) has to be secured to the correct location marked .
Edition Wiring Regulations.
Adequate clearance must be allowed between any point on the rear of the luminaire & the surface above in order to allow
for adequate air circulation.
Please take care as sections of this luminaire can become very hot when under use.
eing lit.
– 17th
10mm
5mm
-
1、Please note: Both lamp
capacity should be at least 5 times the lamp body.
1000W
3、Rotate the light body to the right Angle，
then install the retaining screw
post and screw hole’s weight
11mm
X1
X1
x1
x2
500W
10 mm
1550
x2
2、Install the small plate to the support seat,
Then put the lamp body fixed on the wall
and mount screws
4、Install the safety rope
x2
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------Page No. 2 Issue 1.0 www.anselluk.com
Loading...