Anchor FIESTA FRAME TENT LIFT User Manual

ASSEMBLY INSTRUCTIONS

FIESTA FRAME LIFT

WEB GUIDE
INSERT

WEB GUIDE BOLT
(USE 3/4” WRENCH)

TOP POLE
SECTION

INTERNAL MALE SPLICE
EXTENDS FROM UPPER
END OF BOTTOM POLE
SECTION.

WINCH HANDLE ON WINCH SHAFT

(VIEWED FROM BACKSIDE

RATCHET
BUSHING &
RETAINER
SPRING

RETAINER BOLT &
FLAT WASHER
(USE 1/2” WRENCH)

EAVE HOOK

BOTTOM POLE

STORAGE RINGS (2)
(FOR TOP POLE
SECTION

BASE BOLT
(USE 3/4” WRENCH

BASE SOCKET

WINCH
HANDLE

WEB

RATCHETING

WINCH

IMPORTANT: BOLTS MUST BE
INSERTED IN THIS DIRECTION
(THROUGH WINCH HOUSING AND
THEN THROUGH POLE.

WINCH HOUSING
BOLTS (2). (USE 5/8”
& 9/16” WRENCHES.)

BASE
WHEEL

EC 3194

BASE

FOR MORE STABILITY, INSERT 30”
STEEL STAKES HORIZONTALLY
INTO THESE TUBES AS A
LATERAL BASE EXTENSION.

FL 0808

ANCHOR INDUSTRIES INC

FIESTA FRAME LIFT

ASSEMBLY, USE & MAINTENANCE

TOOLS NEEDED FOR ASSEMBLY:

A.

(1) 3/4” Open End Wrench (Note: Anchor’s Fiesta Wrench has both a
(1) 5/8” Open End Wrench 3/4” end and a 5/8” end.)
(1) 1/2” Open End Wrench
(1) Ratchet Wrench with 9/16” Socket

PART LIST:

B.

The Fiesta Frame Lift is shipped in (2) containers as follows:

1.
(1) Carton, Approximately 6” x 5” x81” containing:
(1) Upright 2-piece pole assembly with base bolt, web guide bolt, and winch
housing bolts (2) pre-installed.

(1) Cardboard Box, Approximately 28” x 11” x 37 1/2” containing:
(1) Base plate with wheels.
(1) 9” x 9” x 21” carton containing (1) winch (assembled with web, web guide, and
eave hook), winch handle, bushing bolt & spring, & flat washer.

C. ASSEMBLY:

1. Remove base bolt from base socket. Insert bottom pole section into base socket.

Replace base bolt and nut and tighten.

2. Remove Top Pole Section from storage rings and lay aside for now.

3. Remove winch housing bolts, nuts, & washers from upper end of bottom pole section.

Position winch at backside of bottom pole section with handle shaft to the right side
as viewed from behind (near the base wheels). Secure the winch by reinstalling the
winch housing bolts through the winch housing and then into the pole. See front cover
illustration for direction. Use a 5/8” open-end wrench inside the winch housing and a
9/16” ratcheted socket on the bolt heads on the outside of the pole to tighten.

4. Slip bushing over the threaded shaft of the winch. Slip retainer spring over bushing.

Attach winch handle with bolt & flat washer provided.

5. Remove web guide bolt and install web guide into upper end of top pole section.

Replace guide bolt and tighten.

6. Lay lift on side and slide top pole section over the male splice at the upper end of the

bottom pole section.

7. Raise lift upright and rotate top pole section until hook is toward the eave bar of the

tent to be lifted. CAUTION: Be sure web is not twisted nor wrapped around pole.

2