Anchor FIESTA FRAME TENT 40 PLUS II RETROFIT User Manual

Page 1
Page 2
Page 3
Page 4
FIESTA® PLUS II RETROFIT
INSTALLATION OF CATENARY WELDMENT
AND INSTRUCTIONS FOR CATENARY TENSIONING
30”
STEPS:
See 40’ Fiesta Retrofit Assembly Instructions, (Retrofit Instructions, Step 3) and install the CWR fitting onto each upright.
Refer to the Retrofit part substitution guide and the standard Fiesta assembly instructions.
With top on, pull corners down and pull web over eyebolt. (See Fig. 4)
Place webs with rings through tri­ring, as shown. (See Fig. 4)
Place hook in top web (double web) into rings, as shown. (See Fig. 1 and Fig. 2)
Attach hook on bottom web to PTEB, as shown. (See Fig. 1 and Fig. 3)
When all hooks are fastened, gradu­ally tension each corner, repeating this process until top is properly tensioned.
Do not over tension at the intermedi­ate legs. Over tensioning can result in the bending of rafters.
1.
2.
3.
4.
5.
6.
7.
8.
SALES OFFICES:
1100 BURCH DRIVE
P.O. BOX 3477
EVANSVILLE, INDIANA 47733,
U.S.A.
PHONE 812-867-2421
FAX 812-867-0547
1-800-544-4445
Quality, Craftsmanship and Service since 1892
PRODUCTION FACILITIES:
BRADENTON, FLORIDA
EVANSVILLE, INDIANA
40RETRO/CAT-0405
FIG. 1
FIG. 3
FIG. 4
FIG. 2
FIESTA® PLUS II UPRIGHTS WITH TOP
RINGS AND WEB-RATCHETS
FOR TENSIONING
CWR
TOP OF UPRIGHT
1/4” DRIVE RIVETS
UPRIGHT
INSIDE
VIEW
UPRIGHT OUTSIDE VIEW
INSTALLATION
OF CWR
Page 5
Thank you for purchasing an Anchor product. In return, we pledge Quality, Service and
Craftsmanship and are available for any questions you may have or assistance you may need.
PHONE NUMBER
812-867-2421
FAX NUMBER
812-867-0547
Anchor products are of superior design and operate best within the parameters of these instruc­tions. It is IMPERATIVE that the instructions be carefully read and COMPLETELY FOLLOWED. Please read installation instructions before the installation or removal of this product. Installation
instructions are available at www.anchorinc.com.
For additional assistance consult: “The IFAI Procedural Handbook For The Safe
Installation And Maintenance Of Tentage” and the IFAI “Pullout Capacity Of Tent Stakes”,
both available from the IFAI Tent Rental Division.
CAUTION:
1. For each installation, the installer is solely responsible for evaluating the site and the proper
securing method determined. Some soils require different staking or securing than that provided with the tent. Due to this variety of soil conditions, these are the manufacturer’s suggested sequence of installation procedures. Anchor ’s responsibility is limited to the construction of the tent. We are not responsible for methods that installers may choose to secure the tent to the ground.
2. Inasmuch as the weather is unpredictable, good judgment and common sense must be incor­porated within installation guidelines. It is the responsibility of the tent installer/maintainer to determine the severity of the weather, proper time and method of installation and/or erection and disassembly.
This product has been manufactured for use as a temporary structure. For the safety of all occu­pants, evacuation is recommended if threatening weather occurs, or if there is any doubt concern­ing the safe use of this product.
3. Proper safety equipment should be used at all times to insure a safe installation and take down. We suggest a careful evaluation be made to determine safety equipment needed, such as hard hats, steel-toe shoes, safety glasses and other as required.
4. Anchor stands behind its products in accordance with its standard Terms and Conditions of sale. Acopy of our Terms and Conditions of Sale can be obtained by contacting Anchor at the telephone number and/or address on this document.
28.2 03/23/05
EVANSVILLE, INDIANA
Loading...