Anchor EVENT AMBASSADOOR WITH VINYL WALLS User Manual

AMBASSADOOR FOR USE WITH VINYL WALLS

INSTALLATION INSTRUCTIONS

5M

Door adapter assembly - one for
each vertical connector tube.

Eave Purlin

Upright (typ.)
Vertical connector tube in­serted into jamb. (typ. 2)

Ambassadoor

ELEVATION

Outside View

Step 1: Door Preparation Assembly

1. Remove door from wood crate utilizing the nylon lifting
straps provided and place face-up (as positioned in
crate) on platform fl oor. (Figure 2)

2. Remove two (2) vertical connector tubes shipped loose
in the wood crate and insert one into the top of each
jamb. The holes in the connector tube must be toward
the top and aligned with the interior/exterior of the frame.
(Figure 3)

Vinyl Wall

Figure 1

3. Loosely bolt one door adapter assembly through the two
holes at the top of each connector tube with the wing
nuts and bolts provided. (Figure 3)

4. Position the Ambassadoor upright directly below the centerline of the eave purlin. Extend each connector tube upward
until the door adapters can be clamped to the eave purlin. Tighten the wing nuts.

5. Level and plumb the ambassadoor. The door is leveled and plumbed correctly when the bottom of each door leaf aligns
and both doors swing without rubbing the threshold.

6. Stake the threshold to the ground with the four (4) galvanized stakes provided in the vinyl hardware bag.

7. Keys for the cylinder lock and allen tool for dogging the panic bars are packed in the hardware bag.

8. Door alignment may need periodic adjustments during normal use.

EC 3554

Figure 2

AMBVMS SW 02-08

Remove vertical connector
tubes shipped loose in wood
crate and insert one into each
jamb as shown.

Door adapter assembly

- clamp to eave purlin and
bolt to vertical connection
tubes with wing nuts and bolts
provided.

Top channel for kedared
velcroed vinyl strip.

Side channel for kedar

Side channel for kedar

Figure 3