Amprobe TIC 300 PRO Quick Start Guide
Meet The New Standard
In Non-Contact, High
Voltage Detection
The Amprobe TIC 300 PRO with VolTect
™
SELF-TEST
Low range
30 V to 1,500 V ac
High range
1,500 V to 122k V ac
LED lights
Shotgun adapter
for hot stick attachment
TIC 300 PRO with VolTect
TIC 300 PRO with VolTect™
Quick Start Guide
On/Off Button:
When the TIC 300 PRO is activated,
the blue LED’s and audible alert
will pulse at a slow rate, approximately twice per second.
SELF-TEST Button:
The TEST button should be used
to ensure tool is operational. The
TEST function will cause the blue
LEDs and audible alert to pulse at
a continuous rate on either LOW or
HIGH range setting.
LOW Range Setting
1. Push ON/OFF button to turn the
unit ON.
2. The unit will default to the high
voltage setting when poweredup. A twice per second beep will
be heard, and the blue LEDs will
flash at the same rate.
3. Push the LOW range button, and
the unit is ready for low voltage
detection.
Sensitivity
Low Voltage
Voltage
(Phase to neutral with
890K Ohm load)
30 V 1.5”
75 V 6.5”
100 V 8.5”
120 V 10”
220 V 1’1”
500 V 1’7”
™
1000 V 2’10”
For complete information on the TIC 300 PRO, visit www.Amprobe.com/TIC300PRO
Detection Range
(From the TIP of probe to
the target line)
Average
4. Place the probe tip of the TIC
300 PRO with VolTect™ near,
but not touching the low (<1000
V) voltage source. See bottom
table for range details.
5. If voltage is present, the blue
LEDs and audible alert will pulse
at an increased rate.
HIGH Range Setting
(> 1500 V and <122 kV)
(TIC 410A Hot Stick must be used)
1. Push the HIGH range setting
button.
2. Approach the probe tip near,
but not touching the high voltage conductor. See bottom table
for details.
3. If voltage is present, the blue
LEDs and audible alert will pulse
at an increased rate.
High Voltage
Voltage
(Open Phase with
no load)
1.5 kV 0.5”
2.0 kV 1”
4.0 kV 2”
10.0 kV 8”
15.0 kV 1’2”
20.0 kV 1’8”
25.0 kV 2’2”
Detection Range
(From the TIP of probe
to the target line)
Average
Loading...