Single/ bi-wiring
For bi-wiring purposes amphion xenon is equipped with two pairs of binding posts. Depending on the market area the speakers can be delivered with lintel installed or separately. In case the two pairs of binding posts are attached with lintel for single wiring and bi-wire use is required the lintels can be removed as follows:
1.Place a rod through the binding post hole.
2.Turn counter-clockwise couple of rounds to loosen the binding post.
3.Remove the lintel.
4.Tighten the binding post by turning them clockwise.
5.Reverse the steps to put the lintel back for single wiring.
xenon english 2/2001
amphion loudspeakers ltd, finland
No: |
www.amphion.fi |
model |
xenon |
impedance |
8 ohm |
max power |
250 W |
BAS Bass Adjustment System
Warrniing:: Use onlly apprroved BAS componentts
Not to be used for connecting speakers to amplifier
Bi-amping
In addition to finding the correct bass level for each room the BAS system can be also used for convenient bi-amping. The advantages of bi-amping are well known, especially when mixing tubes and solid state (tubes for mid and high frequensies and solid state for the bass for example). Now any amplifier combination can be easily balanced and correct bass level found via Bass Adjustment System.
amphion, Uniformly Directive Diffusion, U/D/D-technology and BAS - System
are trademarks of amphion loudspeakers ltd. All rights reserved.
amphion loudspeakers ltd.
P.O. Box 6
70821 Kuopio, Finland
www.amphion.fi
Thank you for choosing amphion xenon. We hope that
your speakers will provide pleasure for years to come.
xenon
User´s Guide
To enjoy fully all the features of your new loudspeakers,
Please read this manual carefully and completely.
Loading...