AMMCO 8899 Tool Kit for Non-vented Rotors User Manual
908899 Tool Kit for 6900 & 6950 Twincutters
Assembly Instructions & Parts Identification
AMMCO Tools, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3564
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX
COMPLETE KIT INCLUDES: Two (2) tool holders, two (2)
cutting tools, two (2) six-edge carbide tool bits, two (2)
replacement springs and one (1) spring extractor.
910710 08/06 1 of 2 © COPYRIGHT 1986 HENNESSY INDUSTRIES AND AMMCO TOOLS ALL RIGHTS RESERVED PRINTED IN U.S.A.
Item Part No. Qty. Description
1 906914 2 Tool Bits, Six-edge Carbide
2 910701 1 Tool Bit Assembly, RH
Bit, Screw & Holder
3 910702 1 Tool Bit Assembly, LH
Bit, Screw & Holder
4 910651 1 Tool Bit Assembly, RH
910650 1 Tool Bit Assembly, LH
(Not Shown)
5 909249 2 Screw, Set
6 906841 2 Pin
7 910711 1 Extractor, Spring
8 906905 2 Spring
910710 08/06 2 of 2 © COPYRIGHT 1986 HENNESSY INDUSTRIES AND AMMCO TOOLS ALL RIGHTS RESERVED PRINTED IN U.S.A.
No. 908899 Tool Kit for Non-vented Rotors
Replaces Standard Cutting Tools.
11
Remove standard cutting tools
from model 6900 & 6950…
…by disconnecting
springs with the AMMCO
spring extractor.
22
Insert new cutting tools.
33
Reconnect Springs.
Insert brass plugs and
turn knobs IN.
Adjust guide screws for
smooth tool holder
movement.
Note: Under each lock
knob there is a brass
plug or brass gib.
Remove knobs &
plugs when replacing
tool holders.
Loading...