AMMCO 40928 4 x 4 Pressed Hub Rotor User Manual
4 x 4 Pressed Hub Rotor
Adapter No. 940928
AMMCO, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
941199 00 07/02 © COPYRIGHT 2002 HENNESSY INDUSTRIES AND AMMCO ALL RIGHTS RESERVED PRINTED IN U.S.A.
The new 3/4 to 1 ton 4 x 4 truck rotor adapter is your
mounting solution for the the 3/4 to 1 ton Dodge/Chevy
spline rotor.
1. Clean the rust and debris from the inner mounting
flange surface of the hub assembly; make sure the center hole is clean from any grease and debris.
Note: Always remove any ABS sensors from the rotor.
2. Slide the backing plate onto any 1-inch arbor with
disk side facing out.
3. Insert front bushing into the front spline of the rotor.
4. Mount rotor onto arbor; install spacers (as needed)
and arbor nut.
5. Install a silencer band.
6. You are now ready to machine the rotor.
No. 940928
Loading...