American Standard 4137.1 User Manual
Installation
Instructions
™
4137.100
Culinaire
Single Control Kitchen Faucet
and Deluxe Pull-Out Spray
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
TOOLS REQUIRED
Certified to comply with ANSI A112.18.1M
M968208 REV. 1.4
Phillips Screwdriver
INSTALL FITTING WITH OR WITHOUT DECK ESCUTCHEON
1
CAUTION
Apply a bead of putty to bottom edge of ESCUTCHEON (1). Note: Installation of ESCUTCHEON (1) is optional.
Make certain the large O-RING (2) is properly seated in recess of faucet body.
Insert supply TUBES (3) and SHANK (4) through center hole of ESCUTCHEON (1) (if used) and sink.
Assemble RUBBER WASHER (5), BRASS WASHER (6), and threaded LOCKNUT (7) onto SHANK (4) from underside
of sink. Hand tighten LOCKNUT (7) and check that rotation of HANDLE (8) from HOT to COLD is centered.
Use a screwdriver to tighten the SCREWS (9) on LOCKNUT (7). Work your way around LOCKNUT (7), tightening
the screws slightly each time until all are snug to ensure even pressure.
Turn off hot and cold water
supplies before beginning.
Channel Locks
Adjustable Wrench
Plumbers' Putty or Caulking
8
2
Tubing Cutter
1
PUTTY
4
3
5
6
9
7
MAKE WATER SUPPLY CONNECTIONS
2
NOTE: FLEXIBLE SUPPLIES HAVE TO BE PURCHASED SEPARATELY
Carefully bend COPPER SUPPLIES to meet water supply
lines using the palms of the hands to avoid kinking.
Connect HOT water supply line to left tube, and COLD
water supply line to right tube using appropriate
connectors.
Use 1/2" IPS FLEXIBLE SUPPLIES (3) or 3/8" O.D.
BULL-NOSE RISERS (4). Use adjustable wrench to tighten
connections. Do not over tighten. Be careful not to kink
copper supply when bending. Use tubing cutter to cut to
proper length.
CONNECT SPRAY HOSE
3
Slide COUPLING NUT (1) onto HOSE (2).
Place WASHER (3) into COUPLING NUT (1) on HOSE (2). Thread COUPLING NUT (1) onto
HAND SPRAY (4) and tighten.
Feed small end of HOSE (2) through BODY (5) so HAND SPRAY (4) rests inside SPRAY HOLDER (6).
Pull KNURLED NUT (7) down over HOSE (2) (thread faces to the small end of the hose).
FERRULE
HOT
34
COLD
Put SMALL RUBBER WASHER (8) in HOSE NUT (9) and screw HOSE NUT (9) onto HOSE END (10) and tighten.
Pull KNURLED NUT (7) up over HOSE NUT (9). Place WASHER (11) into KNURLED NUT (7).
Thread KNURLED NUT (7) onto OUTLET TUBE ADAPTER (12) and tighten.
With HAND SPRAY (4) seated in SPRAY HOLDER (6), install WEIGHTS (13) onto HOSE (2) using two SCREWS (14).
Locate the WEIGHTS (13) two feet (2') from the underside of the sink deck. Tighten SCREWS (14) firmly.
3
1
5
4
2
6
11
12
9
13
14
8
10
7
2
M968208 REV. 1.4
Loading...