American Standard 4110.600, 4110.800, 2898.010 User Manual

254m m

(10)

699m m

(27- 1/2)

C/L OF OUT LET

70mm

(2-3 /4)

FINI SHED W ALL

184m m (7-1 /4)

19mm ± 6mm (3/4 ± 1/4 )

381m m

(15)

470m m

(18- 1/2)

C/L OF SEA T POST HOLES 140m m (5-1 /2 CEN TERS)

305m m

(12)

178mm

(7)

16mm

(5/8 )

FINI SHED FLOO R

762m m

(30)

241m m

(9-1 /2)

152m m

(6)

495m m

(19- 1/2)

222m m

(8-3 /4)

SUPP LY

REQ' D

381m m

(15)

CADET™ ELONGATED 10" ROUGH-IN TOILET

❑ 2898.010

• Vitreous china

• Low-consumption (6.0 Lpf/1.6 gpf)

• 10" roughing-in

• Elongated siphon action jetted bowl

• Fully glazed 2" trapway

• AquaForce ushing technology

• Close-coupled tank with raised lip detail on tank cover

• Color-matched trip lever

• Speed Connect® tank/bowl coupling system

• Sanitary bar on bowl

• 2 bolt caps

• 100% factory ush tested

❑ 3459.016 Bowl ❑ 4110.016 Tank

CADET™

ELONGATED 10" ROUGH-IN TOILET

VITREOUS CHINA

Nominal Dimensions:

699 x 495 x 762mm (27-1/2" x 19-1/2" x 30")

Fixture only, seat and supply by others

Alternate Tank Congurations Available:

❑ 4110.600 Tank complete w/tank cover

locking device

❑ 4110.800 Tank complete w/trip lever located on

right hand side

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Fawn Beige ❏ Black ❏ Seat: American Standard #5324.019 “Rise and Shine” solid plastic closed front, seat with cover. ❏ Seat: American Standard #5311.012 “Laurel” molded closed front seat with cover.

❏ Alternate Seat: ❏ Supply with stop:

NOTES:

THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 254MM (10") FROM FINISHED WALL TO C/L OF OUTLET.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerance established by ANSI Standard A112.19.2 These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

K85

Revised 2/08