American Standard 404, 403, 641 User Manual

INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE

0641 BOULEVARD
0403 TROPIC PETITE
0404 TROPIC GRANDE

Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this
product is installed properly, please read these instructions carefully before you begin. (Certain installations may
require professional help.) Also be sure your installation conforms to local codes.

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

!

NOTE: Pictures may not exactly define contour of china and components.

Recommended Tools & Materials

Level

Putty Knife

Pipe Wrench

Channel Lock Pliers

Adjustable Wrench

Drill

Plumbers' Putty or
Caulking

Tubing Cutter

Phillips Screwdriver

Basin Wrench

Saber Saw

Regular Screwdriver

Tape
Measure

Hacksaw

OBSERVE LOCAL PLUMBING AND BUILDING CODES

This lavatory can be installed 4 different ways. Please follow the instructions for your installation method.

SAVE FOR FUTURE USE

1. PEDESTAL 2. WALL-HUNG ON FURNITURE

In the United States:

American Standard Brands

P.O. Box 6820

Piscataway, New Jersey 08855

Attention: Director of Consumer Affairs

For residents of the United States, warranty
information may also be obtained by calling

the following toll free number: [phone]

www.americanstandard-us.com

Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2009

2480 Stanfield Rd.

Mississauga, Ontario

Canada L4Y 1S2

Toll Free: [phone]

www.americanstandard.ca

In Canada:

AS Canada ULC

3. ABOVE COUNTER 4. DROP-IN

not recommended for 0404

*

Customer Service Manager

AS Maquila, S.A. de C.V.

Ecatepec 55540 Edo. Mexico

www.americanstandard.com/mx

not recommended for 0404

*

In Mexico:

Via Morelos #330

Col. Santa Clara

7301354-100 Rev. B

1. Pedestal installation

1-A

Provide suitable reinforcement
behind finished wall for lavatory
mounting screws.

C/L of 2X6
Support

*

Determine horizontal center line

*

location of support from fixture.

NOTE: If replacing an existing sink
be certain to shut off water supply
before removing old sink.

1-B

Place lavatory and pedestal into installed position. Level and
square the lavatory and pedestal assembly. Use one or more
bumper cushions to level and cushion lavatory slab to pedestal.

1-C

Top of Pedestal

Approx. Bumper locations to
raise the lavatory slab left side.

For example only

Mark lavatory and pedestal screw locations through
the mounting holes.

Finished
Floor

1-D

Remove lavatory and
pedestal from installed
position. Drill pilot holes for
lavatory and pedestal
anchor screws or lag bolts.

1-F

Following manufacturer's
instructions, install faucet and
drain assembly (not included). Be
certain to apply a bead of sealing
putty on the underside of the drain
(area "A") in order to ensure a
watertight seal between the
lavatory and drain. Remove
excess putty after installing
drain on lavatory.

1-G

Return the fitted lavatory to the
installed position. Connect trap to
drain assembly hand tight to check
alignment. It may be necessary to
cut off part of the tailpiece (area
"B") or part of the horizontal leg of
the trap (area "C").

1-H

Secure lavatory to wall as
shown in 1E. Install washers
and hand tighten nuts or lag
bolts. Level and square the
unit. Connect hot and cold
supply lines to the shut-off
valves. Tighten trap joints for
watertight assembly.

1-I

Rear
View

A

C

B

Shut-Off
Valves

Install pedestal screws.
Securely tighten lavatory
anchor nuts or lag bolts.

Note: Some models are supplied with lag bolts, anchor screws,
or steel hangers for lavatory installations only. Other models and
all pedestals are not provided with mounting hardware. Various
pedestal screw sizes and types are available to the installer at
local hardware outlets.

1-E

ANCHOR SCREW INSTALLATION

Install lavatory anchor screws
leaving 1-7/8" threaded end
exposed as illustrated.

1-7/8"

Lavatory

Anchor
Screw

Nut

Washer

IMPORTANT: Final assembly of nut and washer or lag bolt method shown for reference only.

Pedestal
Screws

LAG BOLT INSTALLATION

Use lag bolts to secure
lavatory as illustrated.

Lavatory

Steel
Hanger

Lag
Bolt

Washer

Lavatory

Note: Space constraints
may dictate method of
fastening pedestal to floor.

2

7301354-100 Rev. B