American Standard 4023.014, 2073.014, 3018.013 User Manual

FloWise® 1.28 ELONGATED

305mm

(12)

762mm

(30)

222mm

(8-3/4)

C/L OF OUTLET

FINISHED WALL

19mm ± 6mm (3/4 ± 1/4)

381mm

(15)

C/L

470mm (18-1/2)

C/L OF SEAT POST HOLES 140mm (5-1/2 CENTERS)

254mm

(10)

FINISHED FLOOR

794mm (31-1/4)

267mm (10-1/2)

114mm

(4-1/2)

438mm (17-1/4)

203mm

(8)

356mm

(14)

83mm

(3-1/4)

SUPPLY

REQ'D

16mm

(5/8)

343mm (13-1/2)

Certiﬁed by

IAPMO R&T

HIGH EFFICIENCy TOILET

❑ 2073.014

• Vitreous china

• Meets denition for HET (High Efciency Toilet) – 20% less water usage than 1.6 gpf

• High efciency (4.8 Lpf/1.28 gpf)

• EverClean® surface inhibits the growth of

stain- and odor-causing bacteria, mold, and mildew on the surface

• 4" non-adjustable, piston action Accelerator™ ush valve

• Elongated siphon action jetted bowl

• 2-1/8" fully-glazed trapway

• Speed Connect® tank/bowl coupling system

• Chrome-plated trip lever

• Sanitary Dam on bowl

• 100% factory ush tested

• 2 bolt caps

• 10 year warranty

FloWise® 1.28

ELONGATED TOILET

VITREOUS CHINA

❑ 3018.013 Elongated Bowl ❑ 4023.014 Tank

Nominal Dimensions: 762 x 438 x 794mm (30" x 17-1/4" x 31-1/4")

Fixture only, seat and supply by others

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

• Los Angeles Department of Water and Power Supplementary Purchase Specication for Non-Adjustability

• Certied in EPA WaterSense HET program

• Qualies in LEEDS Programs

To Be Specied:

❏ Color: ❏ White ❏ Seat: (please specify color)

❏ Slow Close Elongated #5325.010 ❏ Rise & Shine Elongated #5324.019 ❏ EverClean® Elongated Seat with Slow Close

Snap-Off Hinges #5321.110

❏ Supply with stop:

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET. SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of xtures are nominal and may var y within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

K39

Revised 2/08