American Standard 4112.700, 2798.012, 4112.300, 4112.500, 4112.600 User Manual

...

305m m

(12)

699m m

(27- 1/2)

C/L OF OUT LET

83mm

(3-1 /4)

FINI SHED W ALL

225m m (8-7 /8)

19mm ± 6mm (3/4 ± 1/4 )

381m m

(15)

419m m

(16- 1/2)

C/L OF SEA T POST HOLES 140m m (5-1 /2 CEN TERS)

305m m

(12)

178mm

(7)

16mm

(5/8 )

FINI SHED FLOO R

762m m

(30)

241m m

(9-1 /2)

152m m

(6)

495m m

(19- 1/2)

222m m

(8-3 /4)

SUPP LY

REQ' D

381m m

(15)

CADET™ ROUND FRONT TOILET

❑ 2798.012

• Vitreous china

• Low-consumption (6.0 Lpf/1.6 gpf)

• Round front siphon action jetted bowl

• Fully glazed 2" trapway

• AquaForce ushing technology

• Close-coupled tank with raised lip detail on tank cover

• Color-matched trip lever

• Speed Connect® tank/bowl coupling system

• Sanitary bar on bowl

• 2 bolt caps

• 100% factory ush tested

❑ 3454.016 Bowl ❑ 4112.016 Tank

Nominal Dimensions: 699 x 495 x 762mm (27-1/2" x 19-1/2" x 30")

CADET™

ROUND FRONT TOILET

VITREOUS CHINA

Fixture only, seat and supply by others

Alternate Tank Congurations Available:

❑ 4112.300 Tank complete with chrome all

metal trip lever

❑ 4112.500 Tank complete with Aquagard Liner ❑ 4112.600 Tank complete with tank cover

locking device

❑ 4112.700 Tank complete with Aquagard Liner

and tank cover locking device

❑ 4112.800 Tank complete with trip lever located

on right side

❑ 4112.900 Tank complete with tank cover device

and trip lever located on right side

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Fawn Beige ❏ Black ❏ Seat: American Standard #5322.011 “Rise and Shine” solid plastic closed front seat with cover. ❏ Seat: American Standard #5308.014 “Laurel” molded closed front seat with cover.

❏ Alternate Seat: ❏ Supply with stop:

NOTES:

THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerance established by ANSI Standard A112.19.2 These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

K87

Revised 2/08