American Standard 3417.016, 4392.001SMT, 2983.012, A112.19.6M User Manual
CADET™ SPECIFIER 16-1/2” H
ELONGATED TOILET
VITREOUS CHINA
CADET™ SPECIFIER 16-1/2”H ELONGATED
TOILET
❏ 2983.012
• Vitreous china
• Low-consumption (6.0 Lpf/1.6 gpf)
• 16-1/2” rim height for accessible and
elderly applications
• Elongated siphon action jetted bowl
• Fully glazed 2” Ballpass trapway
• Fluidmaster Fill Valve
• Large 11” x 9” water surface area
• Close-coupled tank
• Color-matched trip lever
• Sanitary bar on bowl
• 2 bolt caps
• 100% factory flush tested
❏ 3417.016 Bowl
❏ 4392.001SMT Tank
Nominal Dimensions:
756 x 508 x 787mm
(29-3/4" x 20" x 31")
Fixture only, seat and supply by others
To Be Specified
❏ Color:
❏ Seat: American Standard #5324.019 "Rise and
Shine" (with easy to clean lift-off hinge system)
solid plastic closed front seat with cover.
See pageTB-001.
❏ Seat: American Standard #5311.012 "Laurel"
molded closed front seat with cover.
See pageTB-001.
❏ Alternate Seat:
❏ Supply with stop:
© 2004 American Standard Inc.
1/04
SPS 2983.012
NOTES:
THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM
(12") FROM FINISHED WALL TO C/L OF OUTLET.
*
DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.
SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerance
established by ANSI Standard A112.19.2
These measurements are subject to change or cancellation. No responsibility is assumed for use
of superseded or voided pages.
Compliance Certifications Meets or Exceeds the Following Specifications:
• ASME A112.19.2M (and 19.6M) for Vitreous
China Fixtures - includes Flush Performance,
Ball Pass Diameter, Trap Seal Depth and
all Dimensions
FINISHED WALL
756mm
25mm ± 6mm
(1 ± 1/4)
232mm
(9-1/8)
(29-3/4)
508mm
(20)
470mm
(18-1/2)
C/L OF SEAT POST HOLES
140mm (5-1/2 CENTERS)
787mm
SUPPLY
AS
REQ'D
419mm
83mm
(3-1/4)
16mm
178mm
(7)
305mm
(12)
When installed, top of seat is 432 to 483mm (17" to 19") from
the finished floor.
MEETS THE AMERICAN DISABILITIES ACT GUIDELINES AND ANSI A117.1
REQUIREMENTS FOR ACCESSIBLE AND USEABLE BUILDING FACILITIESCHECK LOCAL CODES.
(5/8)
311mm
(12-1/4)
C/L OF OUTLET
(16-1/2)
FINISHED
FLOOR
254mm
*
152mm
(10)
375mm
(14-3/4)
(6)
235mm
(9-1/4)
(31)
Loading...