American Standard 3305.000 User Manual
CADET® 3 RIGHT HEIGHT™
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND
ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USABLE
BUILDING FACILITIES-CHECK LOCAL CODES.
FINISHED WALL
FINISHED
FLOOR
C/L OF OUTLET
SUPPLY
AS
REQ'D.
216mm
(8-1/2)
768mm
(30-1/4)
25mm ± 6mm
(1 ± 1/4)
102mm
(4)
464mm
(18-1/4)
438mm
(17-1/4)
768mm
(30-1/4)
419mm
(16-1/2)
*203mm
(8)
305mm
(12)
356mm
(14)
213mm
(8-3/8)
C/L OF SEAT POST HOLES
140mm (5-1/2 CENTERS)
*352mm
(13-7/8)
*152mm
(6)
238mm
(9-3/8)
ELONGATED COMPLETE TOILET
❑ 3305.000
• Vitreous china
• Low-consumption (6.0 Lpf/1.6 gpf)
• EverClean® surface inhibits the growth of stain
and odor causing bacteria, mold and mildew on
the surface
• Features the Cadet® 3 Flushing System
• 16-1/2" rim height for accessible application
• Elongated siphon action jetted bowl
• Fully-glazed 2-1/8" trapway with 2" ball pass
• Generous 9" x 8" water surface area
• Close-coupled tank with at tank cover for
superior storage
• Oversized 3" ush valve with chemical
resistant apper
• Chrome trip lever
• Speed Connect® tank-to-bowl
coupling system
• Sanitary dam on bowl with four point
tank stabilization
• Includes color-matched plastic toilet seat
and cover
• Wax ring gasket with closet bolts
• 2 color-matched bolt caps
• 100% factory ush tested
• 5 year warranty
CADET® 3 RIGHT HEIGHT™
ELONGATED COMPLETE TOILET
VITREOUS CHINA
Nominal Dimensions:
768 x 438 x 768mm
(30-1/4" x 17-1/4" x 30-1/4")
Fixture only, seat and supply by others
Compliance Certications Meets or Exceeds the Following Specications:
• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter,
Trap Seal Depth and all Dimensions
• Los Angeles Department of Water and Power
Supplementary Purchase Specication for
Non-Adjustability
To Be Specied:
❏ Color: ❏ White
❏ Supply with stop:
NOTES:
THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF
305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.
SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED
SEPARATELY.
DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.
*
IMPORTANT: Dimensions of xtures are nominal and may var y within the range
of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility is
assumed for use of superseded or voided page
© 2008 AS America Inc.
K103
Revised 2/08
Loading...