American Standard 2369.014, 4272.014, 3110.016 User Manual

FIN ISHE D WALL

32m m ± 6mm (1- 1/4 ± 1/4)

387 mm

(15 -1/4 )

FIN ISHE D FLO OR

305 mm

(12 )

721 mm

(28 -3/8 )

C/L OF OUTLET

83m m

(3- 1/4)

216 mm (8- 1/2)

419 mm

(16 -1/2 )

C/L OF SEAT P OST HO LES 140 mm ( 5-1/2 CENTER S)

362 mm

(14 -1/4 )

264mm

(10-3/8)

16m m

(5/ 8)

844 mm

(33 -1/4 )

492 mm

(19 -3/8 )

SUP PLY

REQ 'D

254 mm

(10 )

152 mm

(6)

254 mm

(10 )

356 mm

(14 )

DORAL CHAMPION® 4 ROUND FRONT TOILET

❑ 2369.014

• Vitreous china

•• EverClean® surface inhibits the growth of stain- and odor-causing bacteria, mold,

and mildew on the surface

• Low-consumption (6.0 Lpf/1.6 gpf)

• Features Champion® 4 Flushing System

performance platform

• 4" non-adjustable, piston action Accelerator™

ush valve

• Round Front siphon action jetted bowl

• 2-3/8" fully-glazed trapway

• Speed Connect® tank/bowl coupling system

• Chrome-plated trip lever

• Sweeping pier on bowl

• 100% factory ush tested

• 2 bolt caps

• 10 year warranty

DORAL CHAMPION® 4

ROUND FRONT TOILET

VITREOUS CHINA

❑ 3110.016 Round Front Bowl ❑ 4272.014 Tank

Nominal Dimensions: 721 x 492 x 844mm (28-3/8" x 19-3/8" x 33-1/4")

Fixture only, seat and supply by others

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

• Los Angeles Department of Water and Power Supplementary Purchase Specication for Non-Adjustability - July, 2003 revision

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Silver ❏ Linen ❏ Black ❏ Seat: (please specify color) ❏ Champion® Slow Close Round Front #5330.010 ❏ Rise & Shine Round Front #5322.011 ❏ EverClean® Round Front Seat with Slow Close

Snap-Off Hinges #5320.110

❏ Supply with stop:

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET. SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

K25

Revised 2/08