American Standard 2460.028W, 2461.028W User Manual
CAMBRIDGE™ 5'
WHIRLPOOL AND BATHING POOL
AMERICAST®BRAND ENGINEERED MATERIAL
CAMBRIDGE 5' WHIRLPOOL AND BATHING POOL
❏ 2461.028W Whirlpool Featuring System I
Right Hand Drain Outlet
❏ 2460.028W Whirlpool Featuring System I
Left Hand Drain Outlet
• Americast
®
brand engineered material
• Acid-resistant porcelain finish
• Integral apron with integral 3-sided tile/water
retention flange
• Integral lumbar support with beveled headrest
• Full slip-resistant coverage
• 1.5 HP single speed, self-draining pump/motor
• Factory installed power cord and plug
• Six multi-directional and flow-adjustable jets
• Deck-mounted air switch On/Off
• Two silent air volume controls
• Quick Connect Safe-T-Heater connection system
• Factory installed and tested whirlpool system
Whirlpool Massage featuring System I
❏ 2461.128W Whirlpool Featuring System I
Right Hand Drain Outlet with Grab Bar Drilling
❏ 2460.128W Whirlpool Featuring System I
Left Hand Drain Outlet with Grab Bar Drilling
• Same as above except with grab bar drilling
(grab bar must be ordered separately)
StayClean™ Whirlpool Massage featuring System I
❏ 2461.028WC Whirlpool Featuring System I
Right Hand Drain Outlet
❏ 2460.028WC Whirlpool Featuring System I
Left Hand Drain Outlet
• Same as 2460/2461.028W except with the
StayClean™ whirlpool system featuring
Antimicrobial AlphaSan®
StayClean™ Whirlpool Massage featuring System I
and Grab Bar Drilling
❏ 2461.128WC Whirlpool Featuring System I
Right Hand Drain Outlet with Grab Bar Drilling
❏ 2460.128WC Whirlpool Featuring System I
Left Hand Drain Outlet with Grab Bar Drilling
• Same as 2460/2461.028W except with the
StayClean™ whirlpool system featuring
Antimicrobial AlphaSan®and grab bar
drilling (grab bar must be ordered separately)
© 2006 American Standard Inc.
NOTE: Roughing-in dimensions shown on reverse side of page.
BV-37
Rev. 01/06
Bathing Pool:
❏ 2461.002 Bathing Pool Right Hand Drain Outlet
❏ 2460.002 Bathing Pool Left Hand Drain Outlet
Bathing Pool with Grab Bar Drilling:
❏ 2461.102 Bathing Pool Right Hand Drain Outlet
❏ 2460.102 Bathing Pool Left Hand Drain Outlet
Nominal Dimensions: 1524 x 813 x 451mm
(60" x 32" x 17-3/4")
Bathing Well Dimensions: 1372 x 660 x 432mm
(54" x 26" x 17")
Americast
®
brand engineered material is a
composition of porcelain bonded to enameling
grade metal, bonded to a patented structural
composite.
To Be Specified - Required:
❏ Color:
❏ Bath Faucet: (specify finish)
❏ Bath Drain: 1583.470 (specify finish)
To Be Specified - Optional:
❏ Safe-T-Heater*: 9075.120
❏ Bath Caddie: 9533.100 (in Chrome only)
❏ Jet Trim Ring Kit: 9860.200-two per kit (specify finish)
for Body Massage Jets only
For color/finish availability and other faucet choices,
please see the Product Selector and Pricing Guide.
* NOTE: the Safe-T-Heater is designed to maintain water
temperature during operation. It will not heat cold water to
desired bathing temperature.
BARRIER FREE
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES
AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND
USEABLE BUILDING FACILITIES-CHECK LOCAL CODES.
Install with seat at head end.
CAMBRIDGE™ 5'
WHIRLPOOL AND BATHING POOL
AMERICAST®BRAND ENGINEERED MATERIAL
© 2005 American Standard Inc.
Dimensions of fixtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.4
These measurements are subject to change or cancellation.
No responsibility is assumed for use of superseded or voided
leaflet.
IMPORTANT:
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH
WHIRLPOOL
FOR ADDITIONAL INFORMATION.
SHOWN WITH 8620. SERIES AMARILIS BATH/SHOWER FITTING
AND POP-UP C.D. & O.
LEFT HAND OUTLET SHOWN, RIGHT HAND REVERSE DIMENSIONS (2461).
CONCEALED PIPING NOT FURNISHED.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
■
NOTES:
Compliance Certifications Meets or Exceeds the Following Specifications:
• Underwriters Laboratories - Hydromassage
Bathtubs UL 1795
• ASME A112.19.7M for Whirlpool Appliances
• ASME A112.19.4M for Americast Fixtures
• ASTM F-462 for Slip-resistant Bathing Facilities
• ASTM E162 for Flammability
• NFPA 258 for Smoke Density
GENERAL SPECIFICATIONS FOR 2460/2461 WHIRLPOOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
3
CUBE (FT
)
WHIRLPOOL ELECTRICAL SPECIFICATIONS
SYSTEM I PUMP 1.6 HP, 9.7 AMPS,120V.
60 x 32 x 17-3/4 In. (1524 x 813 x 451mm)
46 Lbs./Sq.Ft. (220 Kgs./Sq.m)
190 Lbs. (86 Kg.)
607 Lbs. (273 Kg.)
50 Gal. (190 L)
41 x 20 In. (1041 x 508mm)
54 x 26 In. (1372 x 660mm)
39 Gal. (148 L)
14 In. (356mm)
13.9
30.9
1524mm
19mm
(3/4)
406mm
102mm
(16)
(4)
102mm
(4)
813mm
(32)
OPTIONAL
TO FLOOR
USUALLY
BETWEEN
1651 & 1981mm
(65 & 78)
+
60mm 13mm
+
(2-3/8) (1/2)
C/L OF 1/2
SUPPLIES
AS REQ'D
C/L OF CURTAIN ROD
USUALLY 1930mm(76) FROM
C/L OF
VALVES
25mm
(1)
SHOWER ARM- 1/2 N.P.T.
32mm(1-1/4) DIA. HOLE
FINISHED FLOOR
(2) 54mm(2-1/8)
(16)
24mm
(15/16)
102mm
406mm
451mm
(17-3/4)
203mm
(8)
C/L OF
DRAIN
DIA. HOLES
(4)
117mm
(4-5/8)
FINISHED
WALL
102mm
(4)
(60)
229mm x 305mm
(9 x 12)
FLOOR
CUTOUT
64mm
(2-1/2)
711mm
70mm
(2-3/4)
PUMP
ON / OFF
SWITCH
(28)
102mm
(4)
SPOUT-
1/2 N.P.T.
76mm
(3)
■
SEE
NOTE
70mm
(2-3/4)
1-1/2 N.P.T. THREADS
1-1/2 O.D. TAILPIECE
FINISHED
WALL
SAFE-T-HEATER
REMOVABLE BLANK
441mm
(17-3/8)
ROUGH
FLOOR
PROVIDE ACCESS TO PUMP FOR
SERVICING ON ALL INSTALLATIONS
19mm
(3/4)
406mm
(16)
102mm
(4)
813mm
(32)
60mm 13mm
(2-3/8) (1/2)
C/L OF 1/2
SUPPLIES
AS REQ'D
USUALLY 1930mm(76) FROM
OPTIONAL
TO FLOOR
USUALLY
BETWEEN
1651 & 1981mm
(65 & 78)
102mm
(4)
+
+
25mm
(1)
SHOWER ARM- 1/2 N.P.T.
32mm(1-1/4) DIA. HOLE
C/L OF CURTAIN ROD
FINISHED FLOOR
C/L OF
VALVES
406mm
(16)
451mm
(17-3/4)
24mm
(15/16)
(2) 54mm(2-1/8)
102mm
203mm
(8)
C/L OF
DRAIN
DIA. HOLES
(4)
117mm
(4-5/8)
1524mm
FINISHED
WALL
229mm x 305mm
(9 x 12)
FLOOR
CUTOUT
102mm
(4)
(60)
64mm
(2-1/2)
70mm
(2-3/4)
711mm
(28)
102mm
(4)
SPOUT1/2 N.P.T.
76mm
(3)
■
SEE
NOTE
1-1/2 N.P.T. THREADS
1-1/2 O.D. TAILPIECE
FINISHED
WALL
70mm
(2-3/4)
441mm
(17-3/8)
ROUGH
FLOOR
GENERAL SPECIFICATIONS FOR 2460/2461 BATHING POOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT3)
60 x 32 x 17-3/4 In. (1524 x 813 x 451mm)
161 Lbs. (72 Kg.)
578 Lbs. (260 Kg.)
50 Gal. (190 L)
41 x 20 In. (1041 x 508mm)
54 x 26 In. (1372 x 660mm)
14 In. (356mm)
43 Lbs./Sq.Ft. (208 Kgs./Sq.m)
13.9
30.9
Loading...