American Standard 2425.118WC, 2425.218W, 2425.218WC, 2425.118W User Manual

HAMPTON™ 5’ INTEGRAL APRON

WHIRLPOOL

HIGH GLOSS ACRYLIC

HAMPTON™ 5’ INTEGRAL APRON WHIRLPOOL

❏ 2425.218W Whirlpool featuring System I

Left Hand Drain Outlet

❏ 2425.118W Whirlpool featuring System I

Right Hand Drain Outlet

• Acrylic with fiberglass reinforcement

• Integral apron with removable access panel

• Integral three-sided, tiling / water retention

flange

• Form-fitted backrest

• 1.5 HP single speed, self-draining pump/motor

with dry run seal

• Factory-installed power cord with plug

• Eight multi-directional and flow-adjustable jets

including:

- Two Ideal-flow jets

- Four body massage jets

- Two recessed back-rest jets

• Deck-mounted air switch On/Off

• Two silent air volume controls

• Quick Connect Safe-T-Heater connection

system

• Factory installed and tested whirlpool system

StayClean™ Whirlpool Massage featuring System I

❏ 2425.218WC Whirlpool featuring System I

Left Hand Drain Outlet

❏ 2425.118WC Whirlpool featuring System I

Right Hand Drain Outlet

• Same as above except with the StayClean™ whirlpool system featuring Antimicrobial AlphaSan®

Nominal Dimensions: 60” x 32” x 21-1/2” (1524 x 813 x 546mm)

BV-19

3/03

Compliance Certifications Meets or Exceeds the Following Specifications:

• Underwriters Laboratories - Hydromassage Bathtubs UL 1795

• ASME A112.19.7M for Whirlpool Appliances

• ANSI Z124.1 for Plastic Bathtubs

• ASTM E162 for Flammability

• NFPA 258 for Smoke Density

NOTE: Roughing-in dimensions and product specifications shown on reverse side of page.

To Be Specified - Required:

❏ Color: ❏ Bath Faucet: (specify finish) ❏ Bath Drain: 1583.470 (specify finish)

To Be Specified - Optional:

❏ Safe-T-Heater*: 9075.120 ❏ Bath Caddie: 9533.100 (in Chrome only) ❏ Jet Trim Ring Kit: 9860.200-two per kit (specify finish)

For color/finish availability and other faucet choices, please see the Product Selector and Pricing Guide.

* NOTE: the Safe-T-Heater is designed to maintain water temperature during operation. It will not heat cold water to desired bathing temperature.

HAMPTON™ 5’ INTEGRAL APRON

WHIRLPOOL

HIGH GLOSS ACRYLIC

NOTES:

BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE INSTALLATION. SUPPORT OF BATH BY SUMP BEDDING. SUPPORT AND ENCLOSING MATERIAL BY OTHERS.

REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION. FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY. PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.

IMPORTANT:

Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1 These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet.

10-1/4

(260mm)

SEE FITTING

SPECS FOR

DIMENSIONS

(813mm)

(19mm)

FINISHED

WALL

(305mm)

3/4

(229 mm)

CUTOUT IN FLOOR FOR DRAIN

(1524mm)

(8) JETS

PUMP

WATER RETENTION FLANGE (3 SIDES)

(406mm)

ON/OFF SWITCH

C/L OF

SUPPLIES

OPTIONAL TO

FINISHED FLOOR

USUALLY BETWEEN

65 & 78

(1651 & 1981mm)

TOP OF

DECK

(76mm)

RETENTION

C/L OF OVERFLOW

ROUGH

FLOOR

BATH

SUPPORT

MATERIAL

C/L OF DRAIN

1" WATER

FLANGE

(3 SIDES)

3-1/2

(89mm)

21-1/2

(546mm)

1-1/2 O.D.TAILPIECE

SAFE-T-HEATER REMOVABLE BLANK

(305mm)

OPT.

1-1/2 N.P.T.M.

THREADS

(2) AIR VALVES

C/L OF SHOWER ARM

FINISHED

C/L OF VALVES

(102 mm)

(70mm)

GENERAL SPECIFICATIONS FOR 2425 WHIRLPOOL

INSTALLED SIZE WEIGHT WEIGHT w/WATER GAL. TO OVERFLOW MIN. OPERATING GAL. BATHING WELL AT SUMP BATHING WELL AT RIM WATER DEPTH TO OVERFLOW FLOOR LOADING (PROJECTED AREA) PTS. CUBE (FT3)

60 X 32 X 21-1/2In.(1524 X 813 X 546mm)

16-1/4 X 38-1/4 In. (413 X 972mm)

26-1/4 X 52-1/2 In. (667 X 1334mm)

43 Lbs./Sq. Ft. (208 Kgs/Sq. m.)

115 Lbs. (52 Kg.)

574 Lbs. (258 Kg.)

55 Gal. (208 L.) 45 Gal. (171 L.)

ACCESS TO PUMP/MOTOR THROUGH REMOVABLE FRONT ACCESS PANEL

WALL

C/L OF SPOUT

TILING FLANGE

21-1/4

(540mm)

REF.

DIM

2-3/4

4-5/8

(117mm)

15 In. (381mm)

15.6

35.3

LEVELING STRINGER NOT FOR SUPPORT

UNDERSIDE OF DECK

WHIRLPOOL ELECTRICAL SPECIFICATIONS

1.6 HP, 9.7 AMPS, 120V.SYSTEM I PUMP