American Standard 2384.014 User Manual

CADET® 3 ROUND FRONT 14" ROUGH-IN TOILET

❑ 2384.014

• Vitreous china

• Low-consumption (6.0 Lpf/1.6 gpf)

• EverClean® surface inhibits the growth of stain- and odor-causing bacteria, mold, and mildew on the surface

• Features the Cadet® 3 Flushing System

• Space saving round front siphon action

jetted bowl

• Fully-glazed 2-1/8" trapway with 2" ball pass

• Generous 9" x 8" water surface area

• Close-coupled tank with at tank cover for

superior storage

• Oversized 3" ush valve with chemical

resistant apper

• Chrome trip lever

• Speed Connect® tank-to-bowl

coupling system

• Sanitary dam on bowl with four point

tank stabilization

• 2 color-matched bolt caps

• 100% factory ush tested

• 5 year warranty

CADET® 3 ROUND FRONT 14"

ROUGH-IN TOILET

VITREOUS CHINA

SEE REVERSE FOR ADDITIONAL ROUGHING-IN DIMENSIONS

❑ 3011.016 Round Front Bowl ❑ 4027.016 Tank

Nominal Dimensions: 768 x 445 x 746mm (30-1/4" x 17-1/2" x 29-3/8")

Fixture only, seat and supply by others

Alternative Tank Congurations Available:

❑ 4027.600 Tank complete with tank cover

locking device

❑ 4027.800 Tank complete with trip lever

on right side

❑ 4027.900 Tank complete with tank cover

locking device and trip lever on right side

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

• Los Angeles Department of Water and Power Supplementary Purchase Specication for Non-Adjustability

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Silver ❏ Linen ❏ Black ❏ Seat: #5330.010 Round front Champion® Slow Close

solid plastic seat and cover with easy lift off feature ❏ Seat: #5282.011 Round Front EverClean® solid plas-

tic seat and cover

❏ Seat: #5320.110 EverClean® Round Front Seat with

Slow Close Snap-Off Hinges

❏ Supply with stop:

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 356MM (14") FROM FINISHED WALL TO C/L OF OUTLET. SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

K71

Revised 2/08

FINISHED WALL

FINISHED FLOOR

C/L OF OUTLET

SUPPLY

REQ'D.

267mm (10-1/2)

768mm (30-1/4)

25mm ± 6mm (1 ± 1/4)

114mm

(4-1/2)

416mm (16-3/8)

445mm (17-1/2)

746mm (29-3/8)

*381mm

(15)

*203mm

(8)

356mm

(14)

337mm (13-1/4)

216mm

(8-1/2)

C/L OF SEAT POST HOLES 140mm (5-1/2 CENTERS)