American Standard 2366.100 User Manual

CADET™ ROUND FRONT

(305 mm)

(737 mm)

C/L OF OUT LET

3-1/ 4

(83m m)

FINI SHED W ALL

225m m (8-7 /8)

3/4 ± 1/4 (19m m ± 6m m)

(356 mm)

16-1 /2

(419 mm)

C/L OF SEA T POST HOLES 5-1/ 2 (140 mm CEN TERS)

12-1 /4

(311 mm)

5-3/4

(146mm)

5/8

(16m m)

FINI SHED FLOO R

(737 mm)

9-3/ 4

(248 mm)

(152 mm)

19-1 /2

(495 mm)

(203 mm)

SUPP LY

REQ' D

(381 mm)

PRESSURE-ASSISTED TOILET

❏ 2366.100

• Vitreous china

• Low-consumption (6.0 Lpf/1.6 gpf)

• Round front bowl

• Pressure-assisted siphon jet ush action

• Fully-glazed 2" ballpass trapway

• 10" x 12" water surface area

• Side-mounted chrome trip lever

• Close-coupled ushometer tank*

• Speed Connect® tank/bowl coupling system

• 2 bolt caps

• 100% factory ush tested

❏ 3083.016 Bowl with four bolt caps ❏ 4098.100 Tank complete with

coupling components

CADET™ ROUND FRONT

PRESSURE-ASSISTED TOILET

VITREOUS CHINA

Nominal Dimensions:

737 x 495 x 737mm (29" x 19-1/2" x 29")

Fixture only, seat and supply by others

Recommended working pressure range 20 psi - 80 psi

Alternate Congurations Available:

❏ 4098.700 Tank and tank cover only with tank

cover locking device

❏ 4098.800 Tank and tank cover only with right

hand trip lever

❏ 4098.900 Tank complete with right hand trip

lever and tank cover locking device

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2 for Vitreous China Fixtures

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Fawn Beige ❏ Black ❏ Seat: American Standard #5322.011 “Rise and Shine" (with easy to clean lift-off hinge system) solid plastic closed front seat with cover. ❏ Seat: American Standard #5308.014 “Laurel" molded closed front seat with cover.

❏ Alternate Seat: ❏ Supply with Stop:

NOTES:

THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY. FOR ADDITIONAL INFORMATION REFER TO INSTALLATION INSTRUCTIONS SUPPLIED.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibilit y is assumed for use of superseded or voided pages.

* Flushmate III tank system by Flushmate® Div. of Sloan Valve Co

M47

Revised 2/08