American Standard 2359.012 User Manual

COLONY™ RIGHT HEIGHT™ ELONGATED

305m m

(12)

756m m

(29- 3/4)

C/L OF OUT LET

76mm

(3-1 /4)

FINI SHED W ALL

229m m (9)

19mm ± 6mm (3/4 ± 1/4 )

419m m

(16- 1/2)

470 mm (18- 1/2)

C/L

C/L OF SEA T POST HOLES 140m m (5-1 /2 CEN TERS)

311m m

(12- 1/4)

178mm

(7)

16mm

(5/8 )

FINI SHED FLOO R

781m m

(30- 3/4)

235m m

(9-1 /4)

152m m

(6)

508m m

(20)

203m m

(8)

SUPP LY

REQ' D

375m m (14- 3/4)

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USABLE BUILDING FACILITIES-CHECK LOCAL CODES.

12" ROUGH-IN TOILET

❑ 2359.012

• Vitreous china

• Low-consumption (6.0 Lpf/1.6 gpf)

• 16-1/2" rim height for accessible applications

• Elongated siphon action jetted bowl

• AquaForce ushing technology

• Fully glazed 2" trapway

• American Standard Aquameter™ Water Control

• Color-matched trip lever

• Sanitary bar on bowl

• 2 bolt caps

• 100% factory ush tested

❑ 3370.016 Bowl ❑ 4392.016 Tank

Nominal Dimensions: 756 x 508 x 781mm (29-3/4" x 20" x 30-3/4")

COLONY™ RIGHT HEIGHT™

ELONGATED 12" ROUGH-IN TOILET

VITREOUS CHINA

Fixture only, seat and supply by others

Alternate Tank Congurations Available:

❑ 4392.500 Tank complete with Aquaguard Liner ❑ 4392.800 Tank complete with trip lever located

on right side

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures - includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

To Be Specied:

❏ Color: ❏ White ❏ Seat: American Standard #5324.019 “Rise and

Shine” solid plastic closed front seat with cover. ❏ Seat: American Standard #5311.012 “Laurel” molded closed front seat with cover.

❏ Alternate Seat: ❏ Supply with stop:

NOTES:

THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED SEPARATELY.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerance established by ANSI Standard A112.19.2 These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

K90

Revised 2/08