FINI SHED
WALL
OR
SPLA SH BAC K
COUN TERTOP
CUTO UT 324 mm
(12- 3/4) D IA.
175m m
(6-7 /8)
349m m
(13- 3/4)
38mm
(1-1 /2)
MIN.
51mm
(2)
MIN.
B
A
C/L
1-1/ 4 O.D.
TAIL PIECE
1-1/ 4 O.D.
WAST E
203m m
(8)
168m m
(6-5 /8)
178m m
(7)
16mm
(5/8 )
COUNTERTOP
(BY OTHERS)
SEALING
COMPOUND
SUPPLIES
AS REQ'D.
305m m
(12)
*
254m m
(10)
*
FINI SHED
FLOO R
787mm
(31)
SUGGESTED
848mm
(33-3/8)
FITTING
CENTER-S ET
SPREAD
A
27mm(1-1 /16)
32mm(1-1 /4)
B
102mm(4)
203mm(8)
848mm
(33-3/8)
51mm
(2)
610mm
(24)
152mm
(6)
MAX.
BARRIER FREE
CLEARAN CE
686mm
(27)
MIN.
203mm
(8)
MIN.
229mm
(9)
MIN.
DRAWING FOR
DIMENSIONAL
PURPOSES ONLY.
IT IS NOT AN EXACT
REPRESENTATION.
ROYTON™ COUNTERTOP SINK
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES
AND ANSI A117.1 ACCESSIBLE AND USABLE
BUILDINGS AND FACILITIES - CHECK LOCAL CODES.
Install lavatory 864mm (34") from finished floor.
Lavatory installed 51mm (2") minimum from front edge
of countertop provides 686mm (27") knee clearance area.
• Made from vitreous china
• Self-rimming with cutout template supplied
• Center drain outlet
• Front overow
❏ 0571.000 Round sink without faucet deck
Nominal Dimensions:
349mm (13-3/4") Round
Bowl size:
273mm (10-3/4") round
140mm (5-1/2") deep
Compliance Certications Meets or Exceeds the
Following Specications:
• ASME A112.19.2M for
Vitreous China Fixtures
ROYTON™
COUNTERTOP SINK
VITREOUS CHINA
To Be Specied:
❏ Color: ❏ White ❏ Bone
❏ Linen ❏ Silver
❏ Fawn Beige ❏ Black
❏ Faucet*:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
* See faucet section for additional models available
© 2008 AS America Inc.
NOTES:
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TR AP
*
ARE SUGGESTED.
FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE
TEMPLATE SUPPLIED WITH SINK.
FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
SEALING COMPOUND SUPPLIED BY OTHERS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to c hange or cancellation. No responsibility
is assumed for use of superseded or voided pages.
J33
Revised 2/08