American Standard 0554.012, 0558.017 User Manual

BARRIER FREE

FIN ISHED WALL OR SPLASH BACK

102 mm

(4)

616 mm

(24 -1/4)

OPT IONAL

183 mm

(7- 3/16)

67m m

(2- 5/8)

457 mm

(18 )

C/L

COU NTERTO P (BY OT HERS)

FINISHED FLOOR

203 mm

(8)

1-1/4 O.D

TAILPIECE

1-1/4 O.D.

WASTE

SUPPLIES AS REQ'D

248 mm

(9- 3/4)

19m m

(3/ 4)

343 mm

(13 -1/2)

SEA LING COM POUND

178 mm

(7)

178 mm

(7)

787mm ( 31)

845mm (3 3-1/4)

845mm (33-1/4)

70mm (2-3/4)

610mm

(24)

152mm

(6)

MAX.

BARRIE R FREE

CLEARA NCE

686mm

(27)

MIN.

203mm

(8)

MIN.

229mm

(9)

MIN.

DRAWING FOR DIMENSIONAL

PURPOSES ONLY. IT IS NOT AN EXACT REPRESENTATION.

ANTIQUITY™ COUNTERTOP SINK

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 ACCESSIBLE AND USABLE BUILDINGS AND FACILITIES - CHECK LOCAL CODES.

Install lavatory 864mm (34") from finished floor. Lavatory installed 70mm (2-3/4") minimum from front edge of countertop provides 686mm (27") knee clearance area.

• Turn-of-the-century detailing on countertop sink

• Made from vitreous china

• Self-rimming with cutout template supplied

• Front overow

• Faucet ledge (faucet not included)

❏ 0558.017 Faucet holes on 8" (203mm) centers ❏ 0554.012 Faucet holes on 4" (102mm) centers

(illustrated)

Nominal Dimensions: 616 x 457mm (24-1/4" x 18")

Bowl sizes:

432mm (17") wide 267mm (10-1/2") front to back 140mm (5-1/2") deep

ANTIQUITY™

COUNTERTOP SINK

VITREOUS CHINA

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Linen *Faucet:

❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap:

* See faucet section for additional models available

NOTES:

DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TR AP ARE

SUGGESTED. FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE TEMPLATE SUPPLIED WITH SINK. FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. SEALING COMPOUND SUPPLIED BY OTHERS.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

J29

Revised 2/08