American Standard 0530.004SG, 0530.008SG User Manual
BARRIER FREE
FINI SHED
WALL
OR
SPLA SH BA CK
451m m
(17- 3/4)
521mm
(20-1/2)
178m m
(7)
76mm
(3)
102mm
(4)
OPTIONAL
C/L
FINI SHED
FLOO R
1-1/ 4 O.D .
TAIL PIECE
1-1/ 4 O.D .
WAST E
203m m
(8)
178m m
(7)
248m m
(9-3 /4)
*
COUNTERTOP (BY OTHERS)
187m m
(7-3 /8)
13mm
(1/2)
SEALING COMPOUND
SUPPLIES
AS REQ'D.
324m m
(12- 3/4)
*
787mm (3 1)
851mm (3 3-1/2)
851mm
(33-1/2)
51mm
(2)
610mm
(24)
152mm
(6)
MAX.
BARRIE R FRE E
CLEARA NCE
686mm
(27)
MIN.
203mm
(8)
MIN.
229mm
(9)
MIN.
DRAWING FOR
DIMENSIONAL
PURPOSES ONLY.
IT IS NOT AN EXACT
REPRESENTATION.
SEYCHELLE™
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES
AND ANSI A117.1 ACCESSIBLE AND USABLE
BUILDINGS AND FACILITIES - CHECK LOCAL CODES.
Install lavatory 864mm (34") from finished floor.
Lavatory installed 51mm (2") minimum from front edge
of countertop provides 686mm (27") knee clearance area.
COUNTERTOP SINK
VITREOUS CHINA
SEYCHELLE™ COUNTERTOP SINK
with Scotchgard
®
• Stylish, distinctively sculpted countertop sink
• Scotchgard® nish for easier cleaning
• Made from vitreous china
• Self-rimming with cutout template supplied
• Front overow
• Faucet shown not supplied
❏ 0530.004SG Faucet holes on 4" (102mm) centers
(illustrated)
❏ 0530.008SG Faucet holes on 8" (203mm) centers
Nominal Dimensions:
521 x 451mm
(20-1/2" x 17-3/4")
Bowl sizes:
406mm (16") wide
254mm (10") front to back
143mm (5-5/8") deep
Compliance Certications Meets or Exceeds the
Following Specications:
• ASME A112.19.2M for
Vitreous China Fixtures
To Be Specied:
❏ Color: ❏ White ❏ Bone
❏ Linen ❏ Silver
❏ Fawn Beige ❏ Black
❏ Faucet*:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
* See faucet section for additional models available
© 2008 AS America Inc.
NOTES:
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TR AP ARE
*
SUGGESTED.
FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE
TEMPLATE SUPPLIED WITH SINK.
FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
SEALING COMPOUND SUPPLIED BY OTHERS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range
of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to c hange or cancellation. No responsibility is
assumed for use of superseded or voided pages.
J39
Revised 2/08
Loading...