American Standard 0498.800, 0498.001, 0498.400 User Manual

BARRIER FREE

FINI SHED

WALL

SPLA SH BA CK

445m m

(17- 1/2)

521mm (20-1/2)

102mm (4)

8mm

(5/16)

TYP.

181m m (7-1 /8)

70mm

(2-3 /4)

OPTIONAL

C/L

FINI SHED

FLOO R

1-1/ 4 O.D .

TAIL PIECE

1-1/ 4 O.D .

WAST E

203m m (8)

178m m

(7)

*24 8mm

(9-3 /4)

COUNTERTOP (BY OTHERS)

178m m

(7)

13mm

(1/2)

SEALING COMPOUND

SUPPLIES AS REQ'D.

318m m

(12- 1/2)

787mm (3 1)

851mm (3 3-1/2)

851mm (33-1/2)

51mm

(2)

610mm

(24)

152mm

(6)

MAX.

BARRIE R FREE

CLEARA NCE

686mm

(27) MIN.

203mm

(8)

MIN.

229mm

(9)

MIN.

DRAWING FOR DIMENSIONAL

PURPOSES ONLY. IT IS NOT AN EXACT REPRESENTATION.

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 ACCESSIBLE AND USABLE BUILDINGS AND FACILITIES - CHECK LOCAL CODES.

Install lavatory 864mm (34") from finished floor. Lavatory installed 51mm (2") minimum from front edge of countertop provides 686mm (27") knee clearance.

ROSELYN™ COUNTERTOP SINK

• Made from vitreous china

• Self-rimming with cutout template supplied

• Front overow

• Faucet ledge Shown with 7411.712 Hampton faucet with porcelain handles (not included)

❏ 0498.800 Faucet holes on 8" (203mm) centers ❏ 0498.400 Faucet holes on 4" (102mm) centers

(illustrated)

❏ 0498.001 Center hole only

Nominal Dimensions:

521 x 445mm (20-1/2" x 17-1/2")

Bowl sizes:

419mm (16-1/2") wide 267mm (10-1/2") front to back 146mm (5-3/4") deep

ROSELYN™

COUNTERTOP SINK

VITREOUS CHINA

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Fawn Beige ❏ Black

❏ Faucet*: ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap:

* See faucet section for additional models available

NOTES:

DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TR AP ARE

SUGGESTED. FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE TEMPLATE SUPPLIED WITH SINK. FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. SEALING COMPOUND SUPPLIED BY OTHERS.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

J37

Revised 2/08