American Standard 0485.027, 0485.033, 0485.013 User Manual

BARRIER FREE

489m m

(19- 1/4)

543mm (21-3/8)

184m m (7-1 /4)

73mm

(2-7 /8)

203mm

(8)

OPTIONAL

FINI SHED

FLOO R

1-1/ 4 O.D .

TAIL PIECE

1-1/ 4 O.D .

WAST E

203m m

(8)

178m m

(7)

11mm (7/16)

273m m

(10- 3/4)

182m m (7-3 /16)

SUPPLIES AS REQ'D.

COUNTERTOP (BY OTHERS)

SEALING

COMPOUND

FINI SHED

WALL

SPLA SH BA CK

327m m

(12- 7/8)

787mm (3 1)

851mm (3 3-1/2)

851mm (33-1/2)

51mm

(2)

610mm

(24)

152mm

(6)

MAX.

BARRIE R FREE

CLEARA NCE

686mm

(27)

MIN.

203mm

(8)

MIN.

229mm

(9)

MIN.

DRAWING FOR DIMENSIONAL

PURPOSES ONLY. IT IS NOT AN EXACT REPRESENTATION.

HEXALYN™ COUNTERTOP SINK

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 ACCESSIBLE AND USABLE BUILDINGS AND FACILITIES - CHECK LOCAL CODES.

Install lavatory 864mm (34") from finished floor. Lavatory installed 51mm (2") minimum from front edge of countertop provides 686mm (27") knee clearance area.

• Made from vitreous china

• Self-rimming with cutout template supplied

• Front overow

• Faucet ledge Shown with 4801.862 Amarilis/Heritage faucet with Triune handles (not included)

❏ 0485.013 Faucet holes on 8" (203mm) centers

(Illustrated)

❏ 0485.027 Faucet holes on 4" (102mm) centers ❏ 0485.033 Center hole only

Nominal Dimensions: 543 x 489mm (21-3/8" x 19-1/4")

Bowl sizes:

432mm (17") wide 305mm (12") front to back 152mm (6") deep

HEXALYN™

COUNTERTOP SINK

VITREOUS CHINA

Compliance Certications Meets or Exceeds the Following Specications:

• ASME A112.19.2M for Vitreous China Fixtures

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Fawn Beige ❏ Black

❏ Faucet*: ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap:

* See faucet section for additional models available

NOTES:

DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TR AP ARE

SUGGESTED FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE TEMPLATE SUPPLIED WITH SINK. SEALING COMPOUND SUPPLIED BY OTHERS.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

J36

Revised 2/08