American Standard 0410.021, 0411.047, 0411.039 User Manual
BARRIER FREE
FINI SHED
WALL
OR
SPLA SH BA CK
467m m
(18- 3/8)
610mm
(24)
191m m
(7-1 /2)
70mm
(2-3 /4)
38mm
(1-1/2)
203mm
(8)
OPTIONAL
FINI SHED
FLOO R
337m m
(13- 1/2)
1-1/ 4 O.D .
TAIL PIECE
1-1/ 4 O.D .
WAST E
203m m
(8)
*
178m m
(7)
16mm
(5/8)
273m m
(10- 3/4)
*
COUNTERTOP (BY OTHERS)
200m m
(7-7 /8)
29mm
(1-1/8)
SUPP LIES
AS R EQ'D
787mm (3 1)
848mm (3 3-3/8)
848mm
(33-3/8)
51mm
(2)
610mm
(24)
152mm
(6)
MAX.
BARRIE R FREE
CLEARA NCE
686mm
(27)
MIN.
203mm
(8)
MIN.
229mm
(9)
MIN.
ELLISSE PETITE™ COUNTERTOP SINK
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES
AND ANSI A117.1 ACCESSIBLE AND USABLE
BUILDINGS AND FACILITIES - CHECK LOCAL CODES.
Install lavatory 864mm (34") from finished floor.
Lavatory installed 51mm (2") minimum from front edge
of countertop provides 686mm (27") knee clearance area.
• Petite stylish countertop sink made from
vitreous china
• Self-rimming with cutout template supplied
• Rear overow
• Large deck area
Shown with 8871.802 Amarilis faucet with
Fabian handles (not included)
❏ 0411.039 Faucet holes on 8" (203mm) centers
(illustrated)
❏ 0410.021 Faucet holes on 4" (102mm) centers
❏ 0411.047 Center hole only
Nominal Dimensions:
610 x 467mm
(24" x 18-3/8")
Bowl sizes:
457mm (18") wide
305mm (12") front to back
165mm (6-1/2") deep
ELLISSE PETITE™
COUNTERTOP SINK
VITREOUS CHINA
Compliance Certications Meets or Exceeds the
Following Specications:
• ASME A112.19.2M for
Vitreous China Fixtures
To Be Specied:
❏ Color: ❏ White ❏ Bone
❏ Fawn Beige
❏ Black
❏ Faucet*:
❏ Linen ❏ Silver
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
* See faucet section for additional models available
© 2008 AS America Inc.
NOTES:
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TR AP
*
ARE SUGGESTED.
FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE
TEMPLATE SUPPLIED WITH SINK.
FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
SEALING COMPOUND SUPPLIED BY OTHERS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to c hange or cancellation. No responsibility
is assumed for use of superseded or voided pages.
J24
Revised
Revised 2/08
Loading...