American Standard 0291.004, 0291.008 User Manual

BARRIER FREE

400mm

(15-3/4")

457mm

(18")

584mm

(23")

203mm

(8")

FINISHED FLOOR

254mm

(10")

295mm

(11-5/8")

19mm

(3/4")

197mm (7-3/4")

OPTIONAL

224mm (8-7/8")

SUPPLIES AS REQ'D

203mm

(8")

FINISHED WALL

OR SPLASHBACK

1-1/ 4 O.D . WAST E

1-3/4" DIA.

STD. DRAIN

OUTLET

1-1/4" O.D. TAILPIECE

SEALING COMPOUND

(BY OTHERS)

COUNTERTOP

(BY OTHERS)

3 Holes

1-3/8" (35mm) Dia.

178mm

(7")

787mm (3 1)

845mm (3 3-1/4)

845mm (33-1/4)

51mm

(2)

610mm

(24)

152mm

(6)

MAX.

BARRIE R FREE

CLEARA NCE

686mm

(27)

MIN.

203mm

(8)

MIN.

229mm

(9)

MIN.

DRAWING FOR DIMENSIONAL

PURPOSES ONLY. IT IS NOT AN EXACT REPRESENTATION.

RETROSPECT COLLECTION

COUNTERTOP SINK

FINE FIRECLAY

RETROSPECT COLLECTION

COUNTERTOP SINK

• Classically-styled countertop sink

• Retrots in any 20" x 17" cutout

• Made from reclay china

• Front overow

• Self-rimming with cutout template supplied

• Part of design matched Retrospect Collection

❏ 0291.004 Faucet holes on 4" (203mm) centers ❏ 0291.008 Faucet holes on 8" (102mm) centers

(illustrated)

Nominal Dimensions:

584 x 457mm (23" x 18")

Bowl sizes: 422mm (16-5/8") wide 286mm (11-1/4") front to back 159mm (6-1/2") deep

Compliance Specications Meets or Exceeds the Following Specications:

• ASME A112.19.9M for Non-Vitreous Ceramic Fixtures

• CAN/CSA B45 Series

To Be Specied:

❏ Color: White only ❏ Recommended Faucet: 2373.701 ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap

MEETS THE AMERICAN DISABILIT IES ACT GUIDELINES AND ANSI A117.1 ACCESSIBLE AND USABLE BUILDINGS AND FACILITIES - CHECK LOCAL CODES.

Install lavatory 864mm (34") from nished oor. Lavatory installed 51mm (2") minimum from front edge of countertop provides 686mm (27") knee clearance area.

NOTES:

DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TR AP

ARE SUGGESTED. FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE TEMPLATE SUPPLIED WITH SINK. FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. SEALING COMPOUND SUPPLIED BY OTHERS.

IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.9M. These measurements are subject to c hange or cancellation. No responsibility is assumed for use of superseded or voided pages.

J31

Revised 5/06