American Energy Systems RP2063 AC User Manual

Wire Harness Assemble AC

Part #RP2063

for Models Baby AC, Win AC, Essex AC & T40 AC

• Unplug unit

• Open both side panels.

• Remove existing wire harness.

• Attach the following:

o Control Board molex connector
o Exhaust Fan white wire to one lead blue wire to one lead
o High Limit Snap Disk two orange wires to both leads
o Vacuum Pressure Switch two grey wires to both leads

N.O.

3

N.C.

2

Attach one grey wire to ‘Com

1’ and one grey wire to ‘NO 3’.

Attached hose to back

connection ‘L’.

RT080 World Magnetics
Vacuum Pressure Switch

COM

1

Attach one grey wire to ‘Com 1’

and one grey wire to ‘NO 3’.

Attached hose to bottom connection

‘P2’.

N.O.

3

N.O.

2

N.O.

1

o Proof of Fire Snap Disk two brown wires to both leads
o Auger Motor white wire to one lead yellow wire to one lead
o Room Air Fan double white wires to one lead pink wire to one lead
o Electrical Plug double white wires towards the inside terminal

black wire towards the outside terminal
green wire to bottom terminal other end of green wire screwed to

base of unit

o Igniter red wire to one lead white wire to one lead

 (these are not plugged into anything if there is not an igniter)

RT080 Clark Controls

Vacuum Pressure Switch

F:\AESBusinessSystems\AES Technical\Piece part instructions\RP2063 Wire Harness AC.doc

F:\AESBusinessSystems\AES Technical\Piece part instructions\RP2063 Wire Harness AC.doc