American DJ Vapor Flow User Instructions

American DJ

W/ ELECTRONIC

THERMOSTAT

ETS

®

VaporFlow™ Introduction

Customer Support: American DJ® provides a toll free customer sup-

port line, to provide set up help and to answer any question should you
encounter problems during your set up or initial operation. You may
also visit us on the web at www.americandj.com for any comments
or suggestions. For service related issue please contact American
DJ®. Service Hours are Monday through Friday 9:00 a.m. to 5:00 p.m.
Pacific Standard Time.
Voice: [phone]
Fax: [phone]
E-mail: [e-mail]

Warning! To prevent or reduce the risk of electrical shock or fire, do

not expose this unit to rain or moisture.

Caution! There are no user serviceable parts inside this unit. Do not

attempt any repairs yourself, doing so will void your manufactures war­ranty. In the unlikely event your unit may require service please contact
your nearest American DJ dealer.

Do not discard the shipping carton in the trash. Please recycle when
ever possible.

SAFETY ISSUES:

NEVER POINT OR AIM A FOG MACHINE TOWARDS PEOPLE OR
THEIR CLOTHING. THIS UNIT EMITS HOT VAPOR AND SHOULD
BE USED WITH THE SAME CARE THAT YOU WOULD OBSERVE
WHEN USING AN ELECTRIC KETTLE OR IRON.

IF THE POWER SUPPLY CORD IS DAMAGED, IT MUST BE
REPLACED BY MANUFACTURER OR ITS SERVICE AGENT OR
SIMILARLY QUALIFIED PERSON IN ORDER TO AVOID A HAZARD.

User Instructions

American DJ

4295 Charter Street

Los Angeles Ca. 90058

www.americandj.com

VaporFlow™ Clean Machine

To help preve n t t h e u n i t f r o m clogging, use American DJ® Clean
Machine™ liquid. Clean Machine is recommended when storing
your fogger, or at least once a month as normal maintenance under
regular usage. Clean Machine removes particle build up in the heater
and gives longer life to the fog machine. Clean Machine is available
through American DJ® dealers in gallon or quart bottles.

©American DJ Supply® - www.americandj.com - VaporFlow™ Instruction Manual Page 2

VaporFlow™ Safety Precautions

VaporFlow™ Product Registration

Safety Issues: This unit may blow a fuse if the maximum allotted load
of 5 amps is reached. If the fuse needs replacement, always replace
the fuse with same exact type that was remove, unless otherwise
instructed by an authorized American DJ

® service technician. Use of a

different type fuse from that which is recommended may cause fire or
electric shock and will void the manufactures warranty.

• To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture

• Do not spill water or other liquids into or on to your unit

• Do not attempt to operate this unit if the power cord has been frayed
or broken

• Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical

The VaporFlow™ carries a one year (365 days) limited warranty.
Please fill out the enclosed warranty card to validate your purchase.
All returned service items whether under warranty or not, must be
freight pre-paid and accompany a return authorization (R.A.) number.
The R.A. number must be clearly written on the outside of the return
package. A brief description of the problem as well as the R.A. num­ber must also be written down on a piece of paper and included in the
shipping container. If the unit is under warranty, you must provide a
copy of your proof of purchase invoice. You may obtain a R.A. num­ber by contacting our customer support team on our toll free customer
support number at [phone]. All packages returned to service
not displaying a R.A. number on the outside of the package will be
returned to the shipper.

shock and fire in case of an internal short

• Disconnect from main power before making any type of connection

• Do not remove the cover under any conditions. There are no user
serviceable parts inside

• Never plug this unit in to a dimmer pack

• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall

• Do not attempt to operate this unit, if it becomes damaged

• This unit is intended for indoor use only, use of this product out­ doors voids all warranties

• During long periods of non-use, disconnect the unit’s main power

• Always mount this unit in a safe and stable manner

• Power cords should be routed so they are not likely to be walked
on, pinched by items placed upon or against them.

• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer. See page 7 for cleaning details

• Heat -The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances

VaporFlow™ Product Features

• A 1000 watt heater

• Includes 15ft wired remote

• Includes built-in hanging yoke (removable)

• Optional wireless remote available

• Flow disbursement fan attachment (removable)

• Disbursement fan is adjustable to several angles

• 4,500 cubic feet per minute fog output

• Electronic Thermal Sensing™
(For Continuous Heating regulation)

• 1 quart removable tank

• Warm-up time: 5 minutes

• The Vapor Flow™ is almost always ready to fog!

• Dimensions: 10” x 10.75” x 21”

• Weight: 15 lbs.

• CE, ETL, and ETLc Listed

(including amplifiers) that produce heat.

• The fixture should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The fixture does not appear to operate normally or exhibits a

marked change in performance.

©American DJ Supply® - www.americandj.com - VaporFlow™ Instruction Manual Page 3 ©American DJ Supply® - www.americandj.com - VaporFlow™ Instruction Manual Page 4

VaporFlow™ General Information

VaporFlow™ Operating Instructions Cont.

General Instructions: To optimize the performance of this product,

please read these operating instructions carefully to familiarize yourself
with the basic operations of this unit. These instructions contain impor­tant safety information regarding the use and maintenance of this unit.
Please keep this manual with the unit, for future reference.

Unpacking: Thank you for purchasing the VaporFlow™ by American

DJ®. Every VaporFlow™ has been thoroughly tested and has been
shipped in perfect operating condition. Carefully check the shipping
carton for damage that may have occurred during shipping. If the carton
appears to be damaged, carefully inspect your fixture for any damage
and be sure all accessories necessary to operate the unit have arrived
intact. In the event damage has been found or parts are missing, please
contact our toll free customer support number for further instructions.
Please do not return this unit to your dealer without first contacting cus­tomer support at the number listed on page two.

VaporFlow™ Operating Instructions

Fog Juice:

Always be sure to maintain an adequate supply of American DJ®
Brand Fog Juice™ in the fluid reservoir. Running the fog machine dry
will cause pump failure and or clogging. This is the largest cause of
failure in fog machines.

Caution: Not all fog juice is manufactured in the same fashion. Please
use American DJ brand fog juice only, using other brands of fog juice
may cause the unit to clog and fail. Not using American DJ
juice will void the manufactures warranty.

® Brand fog

Remote:

Be sure main power is disconnected and connect the remote control
to the rear of the fog machine. To avoid damage to the unit be sure
main power is disconnected before connecting the remote to the unit.
When main power is connected, the red LED on the remote will begin
to glow.

operating at 220 volts. A red LED on the rear of the unit will begin to
glow once main power is applied

Operation:

Fog output must be regulated by the remote control, the unit itself has
no output control. Once the machine has warmed up to normal operat­ing temperature, the green on the remote will begin to glow. The glow­ing Green LED on the remote indicates the unit is ready to emit fog.

To emit fog, press and hold the red button on the remote control.
Fog will continue to emit until the red button on the remote control is
released or the unit has to recycle.

If fog does not come out, after holding the button down for 30 sec­onds, check the fluid tank level and be sure there is fluid going
through the hose.

ETS:

Electronic Thermal Sensing - This feature electronically regulates the
operating temperature of the heater core. When the heater core drops
by one degree it automatically reheats keeping the heater core at opti­mum temperature throughout use. This allows for fog output at virtual­ly any time it is needed. In fact the only time you should not be without
fog is when the unit is warming or the duty cycle has been exhausted
(the output was held down until the entire fog burst was used).

VaporFlow™ Trouble Shooting

If you experience low output, pump noise, or no output at all, discon­nect immediately. Do not continue pushing on the remote button as
this may damage unit. Check fluid level, the external fuse, remote con­nection, and check power from wall. If all of the above appear to be
okay, and the unit fails to operate correctly, the unit will may require
service. Please contact customer support or return the machine to an
American DJ® authorized service center.

Power:

Plug the VaporFlow™ into a matching power supply for your area. The
unit will draw up to 8.5 amps of power operating at 120 volts or 4 amps

©American DJ Supply® - www.americandj.com - VaporFlow™ Instruction Manual Page 6©American DJ Supply® - www.americandj.com - VaporFlow™ Instruction Manual Page 5

Vapor Flow™ Warranty

Vapor Flow™ Specifications

ONE YEAR LIMITED WARRANTY

A. American DJ® hereby warrants, to the original purchaser, American DJ® products to be
free of manufacturing defects in material and workmanship for a period of one year (365
days) from the date of purchase. This warranty shall be valid only if the product is purchased
within the United States of America, including possessions and territories. It is the owner’s
responsibility to establish the date and place of purchase by acceptable evidence, at the
time service is sought.

B. For warranty service, send the product only to the American DJ
charges must be pre-paid. If the requested repairs or service (including parts replacement)
are within the terms of this warranty, American DJ® will pay return shipping charges only to a
designated point within the United States. If the entire instrument is sent, it must be shipped
in its original package. No accessories should be shipped with the product. If any acces­sories are shipped with the product, American DJ® shall have no liability whatsoever for loss
of or damage to any such accessories, nor for the safe return thereof.

C. This warranty is void if the serial number has been altered or removed; if the product is
modified in any manner which American DJ
ability of the product; if the product has been repaired or serviced by anyone other than
the American DJ® factory unless prior written authorization was issued to purchaser by
American DJ®; if the product is damaged because not properly maintained as set forth in the
instruction manual.

D. This is not a service contract, and this warranty does not include maintenance, cleaning
or periodic check-up. During the period specified above, American DJ
parts at its expense, and will absorb all expenses for warranty service and repair labor by
reason of defects in material or workmanship. The sole responsibility of American DJ® under
this warranty shall be limited to the repair of the product, or replacement thereof, including
parts, at the sole discretion of American DJ®. All products covered by this warranty were
manufactured after January 1, 1990, and bear identifying marks to that effect.

E. American DJ® reserves the right to make changes in design and/or improvements upon
its products without any obligation to include these changes in any products theretofore
manufactured.

® concludes, after inspection, affects the reli-

® factory. All shipping

® will replace defective

MODEL - VaporFlow™

WEIGHT: 15 LBS. (10 Lbs W/Fan Removed)
DIMENSIONS: 10”H x 10.75”W x 21”L
FUSE: 120VAC/10A or 220VAC/5A
OPERATING VOLTAGE*: 120v~50Hz or 220v~50Hz/60Hz
WAR M UP TIME: 5 Minutes
TANK CAPACITY: 1 Quart Removable Tank
OUTPUT: 4,500 cubic feet per minute
FLUID TYPE: Water Base American DJ Fog Juice™
DUTY CYCLE: Not to exceed 6 hours plugged in.
HEAT EXCHANGER: 1,000 WATTS
WARRANTY: 1 Year (365 Days)

* Voltage is preset at the factory and is not user selectable.

Please Note: Specifi cations and improvements in the design

of this unit and this manual are subject to change without any
prior written notice.

F. No warranty, whether expressed or implied, is given or made with respect to any acces­sory supplied with products described above. Except to the extent prohibited by applicable
law, all implied warranties made by American DJ
warranties of merchantability or fitness, are limited in duration to the warranty period set forth
above. And no warranties, whether expressed or implied, including warranties of merchant­ability or fitness, shall apply to this product after said period has expired. The consumer’s
and or Dealer’s sole remedy shall be such repair or replacement as is expressly provided
above; and under no circumstances shall American DJ® be liable for any loss or damage,
direct or consequential, arising out of the use of, or inability to use, this product.

G. This warranty is the only written warranty applicable to American DJ
supersedes all prior warranties and written descriptions of warranty terms and conditions
heretofore published.

H. Lamps are not covered under this or any other warranty either written or implied.

©American DJ Supply® - www.americandj.com - VaporFlow™ Instruction Manual Page 7

® in connection with this product, including

® Products and

©American DJ Supply

American DJ Supply Group of Companies World Headquarters:

4295 Charter Street Los Angeles, CA 90058 USA

Tel: [phone] Fax: [phone]

Web: www.americandj.com E-mail: [e-mail]