American DJ
®
User Instructions
T4™ Unpacking
Thank you for purchasing the T4™ by American DJ
been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have
occurred during shipping. If the carton appears to be damaged, carefully inspect your unit for any damage and be sure all equipment necessary to operate the system has arrived intact. In the event damage has
been found or parts are missing, please contact our toll free customer
support number for further instructions. Please do not return the unit to
your dealer without fi rst contacting customer support.
T4™ Introduction
®. Every T4™ has
Customer Support:
American DJ® provides a toll free customer support line, to provide set
up help and to answer any question should you encounter problems
during your set up or initial operation. You may also visit us on the web
at www.americandj.com for any comments or suggestions. For service
related issue please contact American DJ®. Service Hours are Monday
through Friday 9:00 a.m. to 5:00 p.m. Pacifi c Standard Time.
Voice: (800) 322-6337
Fax: (323) 582-2610
E-mail: support@americandj.com
American DJ
4295 Charter Street
Los Angeles Ca. 90058
www.americandj.com
Warning! To prevent or reduce the risk of electrical shock or fi re, do
not expose this unit to rain or moisture.
Caution! There are no user serviceable parts inside this unit. Do not
attempt any repairs yourself, doing so will void your manufactures warranty. In the unlikely event your unit may require service please contact
your nearest American DJ dealer.
Do not discard the shipping cartoon in the trash. Please recycle when
ever possible.
Safety Issues:
This unit may blow a fuse if the maximum allotted load of 6.3 amp
was reached. If the fuse needs replacement always replace the
fuse with same exact type that was remove from the unit, unless
otherwise instructed by an authorized American DJ
Using a different fuse from that which is recommended will void the
manufactures warranty and may cause fire or electric shock.
©American DJ Supply® - www.americandj.com - T4™ Instruction Manual Page 2
® service technician.
T4™ Operating Instructions
T4™ Controls & Functions
Features:
The T4™ is a 4 channel chaser. The T4™ can be set to run in audio
or chase mode. The audio mode will trigger the chase pattern to the
rhythm of the beat. Chase mode will chase without requiring an audio
signal. The T4™ is deigned to run par cans, pin spots, and other small
fixture. You may draw a total of 6.3
A from the controller. Each channel
can draw up to 5A per a channel. Plug your fixtures into the Edison
sockets on the sides of the T4.™ After plugging your fixtures into the
T4™ plug the T4™ into a standard grounded wall outlet. Select your
operation mode and turn the T4™ on. Remember that if you select
the audio operation mode the T4™ will not chase until it receives an
audio signal.
T4™ Operating Modes
Slow:
When the Mode switch is in the “SLOW” position the unit will chase
(step from one to channel to the next) at a slow pace.
Normal:
When the Mode switch is in the “NORMAL” position the unit will chase
at a regular pace.
Audio:
When in the “AUDIO” mode each chase step will be regulated by
low frequencies heard through the built-in microphone.Turning the
speed knob down completely (counter-clockwise) in audio mode will
regulate the chase solely by low frequencies heard through the built-in
microphone. The audio sensitivity is preset by the manufacture and
may be adjusted.
15432
SPEED
Mic
Normal AudioSlow
American DJ
Monitor
1234
FastSlow
TM
®
1. 3-POLE ELECTRICAL OUTLETS -
These are standard Edison 3-pole grounded electrical outlets.
2. INTERNAL MICROPHONE -
The T4™ comes equipped with a built-in microphone to pick-up the
beat of the music. This is used to trigger the controller in the audio
mode. The internal microphone will have no function when chase
mode is selected.
3. MODE SELECTOR SWITCH -
This switch is used to select any of the three operating modes; Slow,
Normal, or Audio.
T4™ Warranty Card
The T4™ carries a 90 day limited warranty. We recommend you fill
out the enclosed warranty card to validate your purchase. All returned
service items whether under warranty or not, must be freight pre-paid
and accompany a return authorization (R.A.) number. If the unit is
under warranty, you must provide a copy of your proof of purchase
invoice. Please contact American DJ
® customer support for a R.A.
number.
©American DJ Supply® - www.americandj.com - T4™ Instruction Manual Page 3
4. LED INDICATORS -
The four channel LED’s will also glow to indicate channel activity.
5. SPEED ADJUSTMENT KNOB -
The T4™ uses a speed control knob to adjust the chase rate of the
built in program. Turning the speed knob in a clockwise direction will
increase the chase rate, turning the speed knob in a counter-clockwise
direction will decrease the chase rate.
©American DJ Supply® - www.americandj.com - T4™ Instruction Manual Page 4