American DJ Snap Shit DMX-D User Manual
American DJ
®
LOS ANGELES, CA. 90058 USA - SNAP SHOT DMX/D PG.1
SPECIFICATIONS:
Lamp: ZB-400 100W, Power: 120V 60Hz
Weight: 3 lbs. Size: 7.75” x 7.75” x 8”
Fuse: 10A.
Thank you for purchasing this American DJ® product. For your convenience this
product has been lamped and is ready to be used, there is no assembly required.
Please read the following instructions before installing or using your new unit.
Product Description:
A new revolution in Strobe Lights! The Snap Shot DMX/D™ is a 100W, ultra light weight Strobe Light.
Features include: plastic high tech case design with hanging bracket, and variable speed control (1 - 60 flashes
per second) and dimming capabilities. The Snap Shot DMX/D™can flash different colored light by replacing the
interchangeable lamp cover, Snap/D™; available colors: red, blue, green, & yellow. .
To replace lamp; unscrew front dome of the fixture. Do not touch lamp with bare fingers, oil from fingers will ruin
lamp. Use a clean, dry cloth for replacement. Replace bulbs; reassemble.
For service, contact your American DJ® dealer.
Caution! Always disconnect from main
power before replacing lamps or servicing unit.
Remember to always replace with same lamp
and fuse.
American DJ
®
User Instructions
Snap Shot DMX/D
™
2
3
45
1
1. Power Switch
2. DMX Addressing or Rate \ Intensity \ Duration
Switches
3.Mode Switches
4.DMX Input
5.DMX Output
PIN 1 GND, PIN2 DATA-, PIN3 DATA +
American DJ
®
LOS ANGELES, CA. 90058 USA - SNAP SHOT DMX/D PG.2
Stand Alone Mode
1. Disconnect power from strobe then turn off all dipswitches, except for Mode Switch 4.
2. You can program rate; intensity; duration. See the table below.
3. Reconnect power then turn on
Rate
Duration
Intensity
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
on
on
on
on
on
on
on
on
on
on
on
on
on
on
on
on
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10 1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
on
on
on
on
on
on
on
on
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10 1 2 3 4 5 6 7 8 9 10
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
on
on
on
on
on
on
on
on
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10 1 2 3 4 5 6 7 8 9 10
Slower
Faster
Dimmer
Shorter
Brighter
Longer
Operating Instructions
Duty Cycle Because the Snapshot DMX can be used for continuous output (ie while simulating lightning). It can build up intense heat it and comes with a program to shut down the unit
for a15 second cool down. The Fastest Rate, Brightest Intensity, Longest Duration setting will
cause unit to shut down within 5 seconds. So plan your Show to make sure all units don’t turn
off at same time.
Loading...