- www.americandj.com - Cross Flash™ Instruction Manual Page 2
Thank you for purchasing the American DJ Cross Flash.
To optimize beam intensity use this xture with a fog machine or other
type of special effect smoke. The Cross Flash™ produces a unique
cross stitch of multi-colored beams of light. These beams cross in an
volume sensitivity knob that will adjust amount of sound it takes to trig-
provides a toll free customer sup-
port line, to provide set up help and to answer any question should
you encounter problems during your set up or initial operation. You
Service Hours are Monday through Friday 9:00 a.m. to 5:00
p.m. Paci c Standard Time.
To prevent or reduce the risk of electrical shock or re, do
There are no user serviceable parts inside this unit. Do not
attempt any repairs yourself, doing so will void your manufactures war-
your nearest American DJ dealer.
Cross Flash™ Unpacking
Thank you for purchasing the Cross Flash™ by American DJ
Cross Flash™ has been thoroughly tested and has been shipped in
perfect operating condition. Carefully check the shipping carton for
damage that may have occurred during shipping. If the carton appears
to be damaged, carefully inspect your unit for any damage and be sure
all equipment necessary to operate the system has arrived intact. In the
event damage has been found or parts are missing, please contact our
toll free customer support number for further instructions. Please do not
Cross Flash™ Introduction
- www.americandj.com - Cross Flash™ Instruction Manual Page 4
- www.americandj.com - Cross Flash™ Instruction Manual Page 3
thoroughly before attempting to operate this unit. These instructions
contain important safety information regarding the use and mainte-
Cross Flash™ General Instructions
This unit may blow a fuse if the maximum allotted
wise instructed by an authorized American DJ
of a different type fuse from that which is recommended may cause fire
or electric shock and will void the manufactures warranty.
other liquids into or on to your unit. To prevent re or shock hazard,
do not expose this product to rain or moisture.
This unit is designed for interior use only. Do not use this unit out
doors. Use of product outdoors will void the warranty.
Always route your power cord out of the way of foot traf c.
electrical cord. This prong is used to reduce the risk of electrical
shock and re in the rare case of an internal short.
Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
This unit is for adult use only. Keep out of the reach of children.
Before plugging your unit in, be sure the source
voltage in your area matches the required voltage for your American
Cross Flash™ before attempting operation.
Just plug this light in, and watch it go. This
fixture is designed to operate as a stand alone unit. It has been tested
and the lamp has been installed at the factory there is no assembly
box. There is no power switch, after plugging the unit the unit will
slowly light up and rotate in a single direction. If there is no lamp
output check the fuse and bulb. If the fuse and bulb are good, please
A sound sensitivity knob is located on the rear of
the unit. Use this knob to control amount of sound it takes to trigger
the unit. Turning the knob in a clockwise direction will increase the
direction will decrease the units sensitivity to sound.
6 Colors / 6 Beams at Once
This fixture is fitted with halogen lamps which are
the oil from your hands will shorten lamp life. Also,
ample time to cool. Remember, lamps are not cov-
ered under warranty conditions.
Cross Flash™ Precautions
Cross Flash™ Features
Cross Flash™ Operation
Cross Flash™ Halogen Lamp Warning