Amana Menumaster ALD510SE Installation Manual

Owner's Manual

Commercial Microwave Oven

Keep these instructions for future reference.
If the oven changes ownership, this manual
must accompany oven.

Contents

Model Identification ............................2

Grounding/Earthing Instructions .........3

Installation ......................................... 3

Display and Features ......................... 4

Using the Oven Control

(Electronic Models) .........................7

Programming the Oven Control

(Electronic Models) .........................8

Electronic Dial Operation ................... 9

Care and Cleaning............................ 10

Before Calling for Service ................. 10

Model Identification

When contacting Amana, provide product information.
Product information is located on oven serial plate.
Record the following information:

Model Number: ____________________________
Serial or S/N Number: _______________________
Date of installation: _________________________
Dealer’s name and address: __________________

________________________________________
________________________________________

Any questions or to locate an authorized Amana servicer,
call Amana ComServ Service Support.

–Inside the U.S.A. or Canada, call toll-free at 866-426-

2621.
–Outside the U.S.A. and Canada, call 319-622-2808.
–Email: [e-mail].

Warranty service must be performed by an authorized
Amana servicer. Amana also recommends contacting an
authorized Amana servicer, or Amana ComServ Service
Support if service is required after warranty expires.

2

Installation

!

!

Unpacking Oven

• Inspect oven for damage such as dents in door or inside oven cavity.

• Report any dents or breakage to source of purchase immediately.

Do not attempt to use oven if damaged.

• Remove all materials from oven interior.

• If oven has been stored in extremely cold area, wait a few hours before
connecting power.

Radio Interference

Microwave operation may cause interference to radio, television, or a similar
oven. Reduce or eliminate interference by doing the following:

• Clean door and sealing surfaces of oven according to instructions in

and Cleaning

• Place radio, television, etc. as far as possible from oven.

• Use a properly installed antenna on radio, television, etc. to obtain
stronger signal reception.

section.

Care

Oven Placement

• Do not install oven next to or above source of heat, such as pizza oven or
deep fat fryer. This could cause microwave oven to operate improperly
and could shorten life of electrical parts.

• Do not block or obstruct oven filter. Allow access for cleaning.

• Install oven on level countertop surface.

• Place warning label in a conspicuous place close to microwave oven.
(50 Hz models only)

• Outlet should be located so that plug is accessible when oven is in place.

WARNING

To avoid risk of electrical shock or
death, this oven must be earthed.

WARNING

To avoid risk of electrical shock
or death, do not alter the plug.

Grounding/Earthing
Instructions

Oven MUST be grounded.

Grounding reduces risk of electric
shock by providing an escape wire for
the electric current, if an electrical
short occurs. This oven is equipped
with a cord having a ground wire with
a grounding plug. The plug must be
plugged into an outlet that is properly
installed and grounded.

Consult a qualified electrician or
servicer if grounding instructions are
not completely understood, or if doubt
exists as to whether the oven is
properly grounded.

A

B

A—Allow at least 4" (10.2 cm) of clearance around top and sides of oven. Proper air

flow around oven cools electrical components. With restricted air flow, oven may
not operate properly and life of electrical parts is reduced.

B—Allow at least 4" (10.2 cm) between air discharge on back of oven and back wall.

Oven Clearances

Do not use an extension cord.

If the product power cord is too short,
have a qualified electrician install a
three-slot receptacle. This oven should
be plugged into a separate circuit with
the electrical rating as provided in
product specifications (available on
Amana’s wavelink website). When a
microwave oven is on a circuit with
other equipment, an increase in
cooking times may be required and
fuses can be blown.

External Equipotential
Earthing Terminal

Equipment has secondary earthing
terminal. Terminal provides external
earthing connection used in addition
to earthing prong on plug. Located
on outside of oven back, terminal is
marked with symbol shown below.

(export only)

DO NOT power spray

No metal pans

3