Amana UXG7480V, UXG7360V User Manual

Wall-Mount Canopy Grill Vent Hood

(45.7 cm)

12"

(30.5 cm)

(

10.2 cm)

24"

(61.0 cm)

30" (76.2 cm) 36" (91.4 cm) 48" (121.9 cm)

Roof Venting Wall Venting

A. Optional decorative duct cover B. 10" (25.4 cm) round vent C. Roof cap D. 10" (25.4 cm) round vent

transition

A. Optional decorative duct cover B. 10" (25.4 cm) round vent and

elbow C. Wall cap D. 10" (25.4 cm) round vent

transition

Calculating Vent System Length

To calculate the length of the system you need, add the equivalent feet (meters) for each vent piece used in the system.

Maximum equivalent vent length is 35 ft (10.7 m).

Vent Piece 10" (25.4 cm) Round

45° elbow 2.5 ft

(0.8 m)

90° elbow 5.0 ft

(1.5 m)

Example vent system

The following example falls within the maximum recommended vent length of 35 ft (10.7 m).

1 - 90° elbow = 5.0 ft (1.5 m)

1 - wall cap = 0.0 ft (0.0 m)

8 ft (2.4 m) straight = 8.0 ft (2.4 m)

Length of system = 13.0 ft (3.9 m)

90 elbow

6 ft (1.8 m)

2 ft

(0.6 m)

Wall cap

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

UXG7360V UXG7480V

Electrical: 120-volt, 60-Hz, AC-only, 15-amp fused electrical circuit is required.

Vented installations

LOCATION REQUIREMENTS

anopy grill vent hood location should be away from strong draft

C areas, such as windows, doors and strong heating vents.

Venting methods

This canopy grill vent hood is factory set for venting through the roof or through the wall. A 10" (25.4 cm) round vent system is needed for installation (not included). The hood exhaust opening is 10" (25.4 cm) round.

NOTE: Flexible vent is not recommended. Flexible vent creates back pressure and air turbulence that greatly reduce performance. Vent system can terminate either through the roof or through the wall. To vent through a wall, a 90° elbow is needed.

Rear discharge

A 90° elbow may be installed immediately above the hood.

INSTALLATION DIMENSIONS

*NOTE:The grill vent hood duct cover is designed to add 12" (30.5 cm) to meet the ceiling or soffit height. Depending on your model, order:

Part Number W10153151 for 30" (76.2 cm) models, Part Number W10153152 for 36" (91.4 cm) models, Part Number W10153153 for 48" (121.9 cm).

IMPORTANT:

Minimum distance “X”: 30" (76.2 cm)

Suggested maximum distance “X”: 36" (91.4 cm)

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.

Ref. W10153187

02-20-09