INSTALLATION INSTRUCTIONS
UMTK27/30Built-InTrimFrameInstallationInstructions
ForusewiththefollowingmicrowaveovenAMC2206B,UMC5200BandJMC5200B
Part No. 8101P680-60
Code No. DE68-03169A
InstallationInstructions
Proper installation is the installer’s responsibility!
Write the model & serial numbers on the owner’s manual.The model number label is located on the oven front.
UL Listed-For use over electric heat source models (Wall Ovens)
•MEW5527, MEW5530, MEW6527, MEW6530
•AEW3530, AEW4530
•JJW8527, JJW8530, JJW9527, JJW9530
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to wall outlet before beginning installation.
Parts,Tools, and Materials
The following parts are supplied with the oven:
Tools required to perform installation:
•Phillips Screwdriver
•Saw (Electric or Hand)
•Drill with 7/64” drill bits (Electric or Hand)
•Tape Measure
•Pencil
•Framing Square
•Level
Shipping Weight
•Approximate shipping weight is 15.7(30”), 14.9(27”) lbs.
Cutout Dimensions
Dimensions |
27” |
30” |
|
|
|
Height |
16 7/8” |
16 7/8” |
|
|
|
Width |
25” |
25” |
|
|
|
Depth (min.) |
23 3/4” |
23 3/4” |
|
|
|
Bracket Base |
Trim Frame |
Left Bracket |
Template 1 |
Bottom Bracket |
template 2 |
Top Bracket |
1” Screw |
|
(1 required, 1 extra) |
|
½” Screw |
|
(14 required, 6 extra) |
WARNING
To avoid risk of electrical shock, personal injury, or death:
•Before drilling into the wall, note where electrical outlets are and where electrical wire might
be concealed behind the wall. YOU COULD GET AN ELECTRICAL SHOCK if you contact electrical wire with the drill bit.
•Locate and disconnect the power to any electrical circuits that could be affected by installing this oven. IFYOU DO NOT
DISCONNECTTHE POWER,YOU COULD GET AN ELECTRICAL SHOCK.
WARNING
To avoid personal injury, wear gloves when handling the metal parts. Parts are sharp and can cause cuts and abrasions.
2
Electrical rating of this oven:
•120 VAC @ 60 Hz
•13 A / 1100 W (USA) / 1000 W (CANADA)
•You need a DEDICATED 120 VAC, 60 Hz, 20 A (USA) / 15A (CANADA), fused electrical supply (located in the cabinet with the microwave as close as possible to the microwave) serving only the microwave.
•Check with a qualified electrician if you are not sure whether the oven is properly grounded or if you do not completely understand the grounding instructions.
•Do not use a fuse in the neutral or grounding circuit.
WARNING
Improper grounding could result in electric shock or other personal injury.
•Save these instructions for the local electrical inspectors use.
•If there is an electrical short circuit, grounding reduces the risk of electrical shock by providing an escape wire for the electric current.This appliance is equipped with a cord having a grounding wire with a grounding plug.
•Place the plug into a properly installed and grounded outlet.
•Amana does not recommend use of an extension cord.
•Keep the power cord dry and do not pinch or crush it.
•Do not, under any circumstances, remove the power supply cord grounding prong!
•This appliance MUST be grounded!
InstallationInstructions
WARNING
If you do not use the microwave oven as instructed, you could be exposed to excessive microwave energy.
Do not expose yourself to excessive microwave energy!
•DO NOT try to operate the microwave oven with the door open.
•DO NOT tamper with or defeat the safety interlocks.
•DO NOT place objects between the microwave oven front face and the door.
•DO NOT allow soil or cleaner residue to build up on the flat surfaces around the microwave oven door.
•DO NOT operate the microwave oven if it is damaged.
•The microwave oven door must close properly to operate safely.
•DO NOT USE THE MICROWAVE OVEN:
•If the door is bent.
•If the hinges or latches are broken or loose.
•If the door seals, sealing surfaces or glass is broken.
•DO NOT ATTEMPT TO ADJUST OR REPAIR THE OVEN YOURSELF!
•It should be adjusted and repaired by a qualified technician who can check for microwave leakage after repairing the oven.
WARNING
If you do not mount the oven as instructed, you risk personal injury and/or property damage.
WARNING
Before you begin installing the oven, PLACE A PIECE OF THE CARTON OR OTHER HEAVY MATERIAL (a blanket) over the countertop or cooktop to protect it. Do not use a plastic cover. Failure to protect these surfaces could result in property damage.
3
InstallationInstructions
1.“UNIT” installment in Bracket Base |
4.“UNIT” installment in cabinet |
Remove 4 screws from the lower right and left parts of outer panel, place “UNIT” in Bracket Base and secure using (4) screws previously removed.
2. Installment of Left Bracket
Assemble the Left Bracket to outer panel and secure with (½”) screw provided.
3. Fixing ‘location screw’ in cabinet
deltornillo Posición
PLANTILLA1
Fix (1) screw at the bottom of cabinet with use of template 1 to loate position of screw in cabinet.
Push “UNIT” into the cabinet aligning fixed screw in cabinet with hole in center rear of Bottom Bracket.
Push “UNIT” in until the front of Bracket Base touches front of cabinet.
5. Installment of Bottom Bracket
B
B
A
A ORIFICIO : TORNILLO
Place Bottom Bracket on Bracket Base (Reference B) Make holes of position A fit to
Bracket Base’s. Drill pilot hole with a 7/64 or #35 drill bit and secure Bottom Bracket with screws
provided.
6. Installment ofTop Bracket
Posición |
|
PLANTILLA2 |
|
del |
tornillo |
|
With template 2, make 2 holes each at the upper right and left parts of cabinet. (Others for the extra)
Secure “Top Bracket” according to the holes.
4
InstallationInstructions
7. Installment ofTrim Frame |
8. Installment ofTrim Frame |
Secure 2 painted screws each at the upper and Lower parts of Trim Frame with door open.
Install Trim Frame to make contact with cabinet.
Trim Frame Dimensions
(Depth of trim Frame is 7/8”)
26 78 " |
29 3 4 " |
1 |
7 16 " |
19 1 8 |
" |
2 |
7 8 " |
19 1 8 |
" |
|
|
|
|
||||
3 1 8 " |
|
|
3 1 8 " |
|
|
||
|
|
27" Trim Frame |
|
|
|
30" Trim Frame |
|
5