See Installation instructions for more safety precautions.
•Refer to the appropriate Parts Catalog for part number information.
•Models listed on page 3.
ALAL
AL
ALAL
This manual is to be used by qualified, professionally trained HVAC technicians only. Goodman does
not assume any responsibility for property damage or personal injury due to improper service
procedures or services performed by an unqualified person.
is a registered trademark of Maytag Corporation or its related companies and is used under license to Goodman Company, L.P., Houston, TX. All rights reserved.
The model number is used for positive identification of component parts used in manufacturing. Please use this number
when requesting service or parts information.
PBC 09 3 E 35 A X A A
BASIC MODEL TYPEMAJ OR/M INO R DES IGN REV.
PBC = Standard Cooler TTW
PBE = Electric Heat TTW
PBH = Heat Pump TTW
COOL IN G CAP AC ITY
09 = 9000 BTUH
12 = 12000 BTUH
RAT ED VOLTA GE
2 = 115V 60Hz 1P h
3 = 230/ 208V 60Hz 1 P h
DESIGN SERI ES (Refrig)
A = R-22
E = R-41 0A
WARNING
WARNING
FEATURE COD
MA = Standard Model R-22
HEATER SIZE
0 0 = no electr ic heat
3 5 = 3.5 kw (2 30/208V)
AX = Standard Mo de l R- 410A
Use up to 4 as needed
In alphabetical order
HIGH VOLTAGE!
Disconnect ALL power before servicing or installing this unit. Multiple power
sources may be present. Failure to do so may cause property damage, personal
injury or death.
WARNING
WARNING
arising from improper service or service procedures. If
you install or perform service on this unit, you assume
responsibility for any personal injury or property damage
which may result. Many jurisdictions require a license to
install or service heating and air conditioning equipment.
Goodman will not be responsible
for any injury or property damage
2
WARNING
WARNING
an "Entry Level Technician" as specified by the AirConditioning, Heating, and Refrigeration Institute (AHRI)
may use this information. Attempting to install or repair
this unit without such background may result in product
damage, personal injury, or death.
ONLY individuals meeting (at a
minimum) the requirements of
PRODUCT IDENTIFICATION
The model number is used for positive identification of component parts used in manufacturing. Please use this number
when requesting service or parts information.
PBC092E00AX
PBC122E00AX
PBC093E00AX
PBC123E00AX
PBE093E35AX
PBE123E35AX
PBH092E12AX
PBH093E35AX
PBH113E35AX
HIGH V OLTAGE!
DISCONNECT ALL POWER BEFORE SERVICING OR
INSTALLING THIS UNIT. MULTIPLE POWER
SOURCES MAY BE PRESENT. FAILURE TO DO SO
MAY CAUSE PROPERTY DAMAGE, PERSONAL
INJURY OR DEATH.
WARNING
WARNING
The United States Environmental Protection Agency (“EPA”) has issued various regulations regarding the introduction and disposal of refrigerants introduced into this unit. Failure to follow
these regulations may harm the environment and can lead to the imposition of substantial fines.
These regulations may vary by jurisdiction. Should questions arise, contact your local EPA office.
WARNING
WARNING
Serious property damage, personal injury, reduced unit
performance and/or hazardous conditions may result
from the use of such non-approved devices.
Do not connect or use any device
that is not design certified by
Goodman for use with this unit.
WARNING
WARNING
do not store combustible materials or use gasoline or
other flammable liquids or vapors in the vicinity of this
appliance.
To prevent the risk of property
damage, personal injury, or death,
3
PRODUCT DESIGN
PBC, PBE and PBH through-the-wall room air conditioners
are designed for window installations in residential applications and are available in 9,000 through 18,000 BTUH sizes.
They are designed for 208/230/115 volt single phase applications.
The provided filter must be installed and under no circumstances should the unit be operated without the filter in place.
Location and Clearances
Be sure electrical service is adequate for chosen model of
air conditioner or heat pump. Complete electrical rating for
unit is found on serial plate located behind front grille. Electrical outlet must be close enough to unit for power cord to
reach without strain.
Air conditioner should be the only appliance on individual
circuit.
For personal safety and to avoid possible damage to appliance or home, observe all safety instructions.
NOTES:
1. Mechanical experience is required to install the air
conditioner or heat pump.
2. Installation can take from 1 to 3 hours, depending on
installer’s knowledge and skill.
3. If you encounter problems during installation, call our
consumer information line toll-free at 1-877-376-0214 (U.S.
and Canada only). If your problem cannot be resolved by
phone, contact an authorized Amana
El ect ric Heat Wat t s3500 - 2900 35 00 - 2900
El ect ric Heat A m ps15 / 1415 / 14
Heatpump ------
Heatpump Watts ------
Heatpump Amps-----Fan W atts Indoor64 Indoor 64 Indoor
Fan W atts Outdoor123 Outdoor123 Outdoor
Voltage230 -208230 -208
Pl ug Ty pePerp end icul arPe rpendicu lar
Po wer Cord Rating2 0 amp20 am p
Po wer Cord TypeLCDILC DI
Power Cord length6 feet6 feet
Dehum idifica ti on: pin ts / hr.41 oz. / hr55 oz./ hr
Fan Speeds
9200
8900
11 800
11 400
CFM cool in g : High-Low265/-26 5/ -
Fan Only S peed3 Speed3 Speed
Controls
Therm ost at temp . ran ge64° - 86°64° - 86°
Outercase : insulation panelsPBWS01APBWS01A
Conden s at e Dr ain S poutY es on Outercas eYes on Outercas e
Therm ost at ic Dra in Val v eY esYes
Ad just abl e chan geover thermost at-----Chassis Size26"26"
Ch as s is H eighth15.625"15.62 5"
Chassis Width26"26"
Ch as s is D epth16. 875"16.875"
6
Loading...
+ 12 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.