Undercounter Dishwasher
PRODUCT MODEL NUMBERS
ADB1500AD
DRAIN REQUIREMENTS
■ Make sure to use an air gap if the drain hose is connected
to house plumbing lower than 20" (508 mm) above
subfloor or floor.
Use of air gap
Air gap
1
■ Use
/2" minimum I.D. drain line fittings.
■ If required, the air gap should be installed in accordance
with the air gap installation instructions. When you are
connecting the air gap, a rubber hose (not provided) will
be needed to connect to the waste tee or disposer inlet.
ELECTRICAL REQUIREMENTS
You Must Have:
■ 120-volt, 60 Hz, AC-only, 15- or 20-amp, fused
electrical supply
■ Copper wire only
We Recommend:
■ A time-delay fuse or circuit breaker
■ A separate circuit
If Connecting Dishwasher with a Power Supply Cord:
■ Use a UL Listed power cord kit marked for
use with dishwasher (Part Number 4317824).
■ Power supply cord must plug into a grounded
3 prong outlet, located in the cabinet next to
the dishwasher opening. Outlet must meet all
local codes and ordinances.
If Connecting Dishwasher with Direct Wiring:
■ Use flexible, armored, or nonmetallic
sheathed copper wire with grounding wire
that meets the wiring requirements for
your home and local codes and ordinances.
■ Use a UL Listed/CSA Approved metallic strain relief.
WATER SUPPLY REQUIREMENTS
■ A hot water line with 20 to 120 psi (138 to 862 kPa) water
pressure can be verified by a licensed plumber.
■ 120°F (49°C) water at dishwasher
3
■
/8" O.D. copper tubing with compression fitting or flexible
braided water supply line (Part Number W10278635RP).
NOTE: 1/2" minimum plastic tubing is not recommended.
■ A 90° elbow with
(Part Number W10574777).
■ Do not solder within 6" (152 mm) of the water inlet valve.
3
/4" hose connection with rubber washer.
Because Whirlpool Corporation policy includes a continuous commitment
to improve our products, we reserve the right to change materials and
specifications without notice.
Dimensions are for planning purposes only. For complete details, see
Installation Instructions packed with product. Specifications subject to
change without notice.
Page 1 of 2
W10788856-D-AM
12/16
Because Whirlpool Corporation policy includes a continuous commitment
to improve our products, we reserve the right to change materials and
specifications without notice.
Dimensions are for planning purposes only. For complete details, see
Installation Instructions packed with product. Specifications subject to
change without notice.
Page 2 of 2
W10788856-D-AM
12/16