Power button – press and hold for 3 seconds to turn on/off,
press and hold 6 seconds to reset
Next pg button – press to turn to next page Previous pg button – press to turn to previous page OK / Enter Button Zoom button – press to adjust the font size or to zoom in/out Menu button – press to display Option Menu Directional buttons – to move cursor
Music button – to enter into music menu
Return button – press once to return to previous menu, press
12
13
14
15
16
17
18
Getting Started
and hold to return to Home menu
Earphone jack Mini USB jack – for data transfer and charging SD cart slot – supports SD/SDHC/MMC card DC jack – for charging LED indicator Speaker
Power On and Off AEBK07FS
Press and hold the [Power] button for 3 seconds to turn on
AEBK07FS.
When AEBK07FS is on, press and release the [Power] button for
standby mode, press and release the [Power] button again to
return to power on mode.
To turn off AEBK07FS, press and hold the [Power] button for 3
seconds.
Charging AEBK07FS
The battery is not fully charged and it is highly recommended that you
charge your LIBRE before you begin using it.
Note: Using the LIBRE “out of the box” will not harm the device. You
will experience reduced battery life as the unit will not be fully
charged.
Connect the power adapter to the LIBRE’s USB port and you will see
an animation of a battery charging on the LIBRE’s display. Please
charge the battery for a minimum of six (6) hours using the power
adapter. You may also charge the battery by connecting your LIBRE to
the USB port of your PC using the USB cable included with your LIBRE.
However, using this method will extend the charging time to
approximately twelve (12) hours.
When DC/USB power cable is connected to AEBK07FS for charging,
Getting Started
AEBK07FS will go into standby mode after it is idle for 60 seconds.
Press the [Power] button to start AEBK07FS.
The battery status is displayed at the bottom left corner. The
remaining battery playback time is displayed right next to the
battery icon.
Inserting Memory Card
AEBK07FS supports SD/SDHC/MMC card in both FAT and NTFS file
system. NTFS is needed to copy file with size larger than 4GB.
To insert a Memory card:
Open the SD cover.
Check that the SD card is in the correct position with the contact
pin facing upwards as illustrated below. You may damage the card
and AEBK07FS if SD card is not inserted in the right orientation.
Push the SD card into the card slot until it clicks.
To remove SD card, push the SD card once again until it clicks.
When a SD card is inserted in or ejected from AEBK07FS, it may
take few seconds for AEBK07FS to update the content.
Please avoid inserting or ejecting SD card when other operation is
running.
Do not remove the card if the content inside the card is being
played. This will halt the operation of AEBK07FS and cause
AEBK07FS to restart.
If the system is not responding, press and hold the <Power>
book. Press <OK> button to
open the last page read.
2. Library
-display the list of books
available. Move the cursor to the
desired title and press <OK> to
open it.
3. Battery Indicator
-displays battery status during
operation
4. Page Number
-displays current page number
and total available pages.
5. Time & Date
-display current time and date,
you can set this from the
[Settings]
6. File Directory
- indicates the location where the
file is stored. SD – SD card, INT –
internal memory
Getting Started
button for 6 seconds to reset.
Limitations with NTFS file system:
Books in the card are not recognized by ADE when connected to
PC.
Direct copy of files from internal memory to card is not supported.
Starting from Home Menu
When AEBK07FS is turn on, you will enter into the Home Menu.