Alpine KTX-WXE-M38 User Manual
KTX-WXE-M38
Car Model Model Year
INSTALLATION KIT
MAZDA 3
2012
Owner’s Manual
This owner’s manual will give you clearly understanding about installation.
For making installation correctly, please read this manual carefully before operating installation.
1 Component Parts
Audio Panel
Alpine-Mazda power cord Bracket
2 Connecting Diagram
For other Audio connectivity
please refer to the head unit
Owner’s manual.
Alpine-Mazda
Antenna cable
ALPINE ELECTRONICS OF ASIA PACIFIC CO., LTD.
555 Rasa Tower 1, Unit 2601-2602, 26th Floor, Phaholyothin Rd.,
Chatuchak, Bangkok, Thailand 10900
Tel : +662-937-0505 Fax : +662-937-0569
http://www.alpine-asia.com
4 1
IN INT (Pink)
P.ANT (Blue/White)
P.BRK (Yellow/Blue)
Connect the connector
tightly into the port.
Alpine-Mazda
Power cord
Mazda audio
connector
3 Removing Vehicle Parts
5 Bracket Assembly
A/C Console
1
1. Remove A/C console 1 by
removing 2 clips off.
2. Remove A/C connector
2
Screw
2 Pcs.
from A/C console.
Bracket
1
A/C Connector
2
4
Screw 2 Pcs.
3
3
3. Remove all 2 screws
4. Remove all connectors
.
4
from the head unit. Then,
remove the head unit.
!!! Caution !!!
Make sure that all the accessories
are off so that you do not cause a
spark.
Screw
2 Pcs.
3
Screw 4 Pcs.
4 Harness Connection 6 Retracing Vehicle Parts
1. Connect the Alpine-Mazda
1
power cord
into the car
connectors.
Alpine-Mazda
antenna cable
Antenna cable
2. Connect the Alpine-Mazda
2
antenna cable
into the car
A/C Connector
antenna connector.
!!! Caution !!!
2
Power cable (24Pin)
1
Alpine-Mazda
power cord
Connect these
connectors firmly
Make connection between
connectors tightly (until you
hear “Click”.)
3
1
Alpine-Mazda
power cord
3
Screw 4 Pcs.
2
Audio Panel
A/C Console
4
2
Screw 2 Pcs.
Audio head unit
Connect Alpine-Mazda
power cord into unit
1. Install bracket 1 both left and
right side of the audio panel by
using 4 screws (2 screws each
side).
2
2. Install audio panel
into the
head unit by insert from rear
side of the head unit.
3. Drive 8 screws (4 screws each
side) to make it tight between
bracket and the head unit.
1. Connect Alpine-Mazda
1
connector
into the head unit
tightly until you hear “Click”.
2
2. Drive 2 screws
to make it
tight between the head unit
and car console.
3. Connect A/C connector
3
with A/C console.
4
4. Install A/C console
into car
console by pressing all clips to
dash panel until you hear
“Click”.
Remark
Perform full function checks for
the head unit. If no problem
found assemble back all the
parts to their original position.
2 3
Loading...