Alpha SPI User Manual

Power

Tools Required:

• Channel lock pliers

• 1" torque wrench set
to 130 in/lbs

Assembly Time:
Approx. 10 minutes

Alternate SPI

Alternate SPI

®

SPI Installation Instructions

Primary SPI

1.

Locate opening for SPI
installation. A knockout is
reserved for installation of a
secondary SPI (if required).

For more information visit www.alpha.com

United States Bellingham, Washington Tel: [phone] Fax: [phone]
Canada Burnaby, British Columbia Tel: [phone] Fax: [phone]

Alpha Technologies reserves the right to make changes to the products and information contained in this document without notice.
Copyright © 2008 Alpha Technologies. All Rights Reserved. Alpha® is a registered trademark of Alpha Technologies. member of The Alpha Group™ is a trademark of Alpha Technologies.
745-997-C0-001, Rev. A (06/2008) To report errors in this document, send email to [e-mail]

2.

Hold the SPI in place using
channel lock pliers while
tightening nut. Torque to
130 in/lbs.

3.

Connect SPI to power supply.
For wiring instructions, refer
to the XM Series 2 Technical
Manual, which can be
downloaded at www.alpha.com.

member of The Group

TM