Alpha R2006I Specsheet

R2006 / R2007 Series Alphatone™ Chime Tone Units

Product Specification Sheet

APS384

Rev. 07 /20 13

Model R2007 Shown

AR C HIT EC T S' AND ENG INEER S'

SPECIFIC AT IO NS

The Alphatone™ chime tone unit(s) shall be
Alpha®/S.T.R.™ R2006 or R2007 or approved equal.

The R2006 shall be used with t he HT2006 series handsets
when one (1) or more door stations need t o send an
audible signal to any of the inside handsets.

T he R2007 shall be used an any HT2000 and/or HT3000
series handsets, when the electric buzzer needs to be
replaced with a more pleasing sounding chime/tone unit,or
as a stand-alone tone unit.

Contractor shall obs erve all local and national electrical
and building codes.

SPECIFIC AT IO NS

R2007

Operating
Voltages:

9-12VDC (polarity sensitive) or
8-16VAC (no polarity)

R2006 / R 2007 SERIES ALPHAT ONE™ UNIT S

The Alpha®/S.T.R.™ R2006 and R2007 Series
Alphatone™ units are designed to work with our HT2006,

HT2000 and HT3000 series handsets, respec tively.

T h e R2006 units work only with the HT2006 series
handsets, and are used when there is one (1) or more
door entry st ations that need to send an audible t one
signal to any of the inside HT2006 handset stations.
Typically the R2006 units are used in interc om or video-
intercom systems, using t he NH208TVU intercom/door
station power supply/amplifier.

Th e R2006 Alphatone™ units simply plug onto the
pin assembly, found inside the HT2006 handset on the
PC board. The actual tone mechanism is provided with a
selfstick t ape to allow it to be mounted inside the
handset casing.

T h e R2007 units work with almost any of the HT2000
and/ or HT3000 series handsets, and are used when you
wis h to change the electric buzzer, to a warble chime
tone sound instead. They c an also be used as stand­alone signaling devices, or to replace buzzers found in
other manufac turers handsets or equipment.

T h e R2007 Alphatone™ unit has two (2) wire leads
with push-on connect ors. Simply remove t he single screw
that holds the buzzer in place, slide off t he t wo (2) buzzer
wire leads, screw the R2007 in place of the buzzer, and
place the wire leads where the buzzer wire leads were
originally installed. When used as a stand-alone signaling
device, you c an snip the c onnec tors off of the wire leads
and splice t o t he wires directly

FEAT URES

Easy Installation
Operates on AC or DC power
Adjustable potent iometer for chime tone sound
adjustment

Model R2006 Shown

Alpha Communications

42 Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone]

TOLL-FREE: [phone] • Web: www.alphacommunicat ions.com • Email: [e-mail]

C opyright© 1998-2019 Alpha C om munica tions - All Righ ts Reserved.

Due to continuous product improv ement, all co lors, s ize s, m ateria ls, finishes and s pecifications a re subje ct to cha nge without notice .

®