Alpha PHSD User Manual

PWE High Security Device

Power

Field Installation Instructions

The PWE High Security Device (PHSD) mounts to PWE-3, 6, 9, or D36 enclosures to provide security from theft and
vandalism for batteries and power supplies. The PHSD is high grade stainless steel, which not only provides physical
security, but corrosion resistance and a strong visual deterrence as well.

WARNING!

Use EXTREME CAUTION when drilling into the enclosure. Clear equipment and wiring from the
area into which you are drilling.

PWE High Security Device Kit

Tools Required:

• 3/8" drive hand drill

• 9/32" (#K) drill bit

• 7/16" nut driver or socket

Dimensions and Specifi cations

Material List, PWE High Security Device

Alpha P/N Description Qty

605-404-G1-002 Side Bracket 1
605-405-G1-002 Side Bracket with Lock 1
605-406-G1-001 Security Bar 1

630-109-12 Bolts, 1/4" 20x3/4" 8
633-013-12 Flat Washers 8
634-059-12 KEPS Hex Nuts, 1/4-20 8

A

B

In addition:
A security lock (Master Lock
No. 3 or equivalent) is required
to secure the enclosure. The

C

user-supplied lock must meet the
following dimensions.
Where:
A= 1/4" (6.35mm)
B= 5/8" (15.84mm)
C= 1/2" (12.7mm)

®

Left side view

1 1/4"

(31.49mm)

(50.8mm)

2"

7 1/2"

1 5/8"

(41.27mm)

(190.5mm)

(50.8mm)

2"

7 1/2"

1 3/8"

(34.92mm)

(190.5mm)

Fig. 1, PWE-3 Enclosure

1 1/4"

(31.49mm)

Right side view

Total Power Solutions

m

Argus Cordex™ CXRC 2RU SeriesArgus Cordex™ CXRC 4RU Series

Installing the Security Bar

Referring to Fig. 1 for accurate measurements, position

1.
the right side bracket on the right side of the enclosure.
See Figs. 2 and 3.

Mark and drill the four mounting holes.

2.
Use the bolts and nuts provided to secure the bracket

3.
to the enclosure.

Repeat steps 1, 2, and 3 for the left side bracket. See

4.
Figs. 2 and 4.

To attach the security bar to the right side bracket,

5.
insert the bracket tab into the slot on the security bar.

To attach the security bar to the left side lock bracket,

6.
align the center holes and fasten using an appropriate
lock.

Fig. 3, Right side

Left Side

Right Side

Fig. 4, Left side

Fig. 2, Brackets

Fig. 5, Front view

For more information visit www.alpha.com

United States Bellingham, Washington Tel: [phone] Fax: [phone]
Canada Burnaby, British Columbia Tel: [phone] Fax: [phone]

Alpha Technologies reserves the right to make changes to the products and information contained in this document without notice.
Copyright © 2006 Alpha Technologies. All Rights Reserved. Alpha® is a registered trademark of Alpha Technologies. member of The Alpha Group™ is a trademark of Alpha Technologies.
745-881-C4-001, Rev. A (07/2006)

ember of The Group

TM