Allied Telesis iMAP XE1 User Manual

Datasheet | integrated Multiservice Access Platform

XE1

AT-TN308-A 10 Gigabit Ethernet Network Module

egation of GbE Network Traffic

Aggr

The XE1 module available for use with the
iMAP 9000 series is a new advancement in
network card flexibility and capacity supporting
10GbE. As network bandwidth continues to
grow, Service Providers find increasing
bandwidth requirements farther in the local
loop.The ability to maintain a single IP
infrastructure to address Network Transpor t
bandwidth as well as last mile access bandwidth
is pivotal for any network operator.The XE1
module is primarily intended to be used as
an aggregation element with the introduction
of Allied Telesis’ 10G iMAP common control
upgrade (CFC56) and the GE8 service module.
Combined, these modules provide 10G
transport bandwidth as well as aggregation
of up 8 EPSR
flexible, reliable and dense aggregation point
from any network location. As network designs
continue to blend the line between Access
and Transport, the XE1 will become a key
component of an
Triple Play network design.

The XE1 network module, available for use
with the iMAP 9400 and iMAP 9700 chassis
groups equipped with the CFC56 controller
module, is a new advancement in protected
10 Gigabit aggregation speed and transport.
The XE1 provides unmatched flexibility for the
aggregation of bandwidth-intensiv
and ser
Play over any media (Fiber, Copper and xDSL)
as well as Carrier Ethernet ser vices to
residential and b
to support the carrier-class capabilities from
the Allied Telesis Network Module family (GE3)
in addition to increased capacity and the
enhanced QoS capabilities.

TM

rings providing an extremely

y Carrier Ethernet and IP

vices including the deliv

usiness customer

e applications

ery of IP Triple

It contin

s.

ues

o Ethernet Connectivity

Metr

Up to 2 XE1 Network Modules are supported
per an iMAP 9400 or 9700 platforms providing
unprecedented capabilities for the delivery of
user-centric services as well as network traffic
aggregation. When used in conjunction with the
CFC56, the 10 GE ports can be used as either
as network interfaces for subtended remote
locations using EPSR protected transport rings
with sub 50ms failover, aggregation into Metro
routers (Provider Edge) or for point-to-point
connectivity between PoPs. This is in addition

wing the service provider to suppor t at

to allo
wire-speed non-blocking up to 17 different
service modules in the iMAP for delivering
value-add next-generation broadband services
and applications.

Part of Allied Telesis’ IP Broadband
Access Family

Whether it is Metro Ether
Broadband VDSL2/ADSL2+, FTTH or POTS,
the iMAP famil
mile service deliver y. Added to the ability to
support 100% of the available iMAP ser vice
modules,
been designed to survive the most rugged
environmental conditions. This makes it perfect
choice for networks which require high
flexibility and car
the oper

Provisioning, management and diagnostics of
subscriber ports can be accomplished from
either the iMAP command line interface or via

Allied

the
supported SNMP interface and supports all the
major MIBs.

y is the ideal platform for last

the XE1 netw

rier capabilities anywhere in

netw

s’

ator

View NMS.

net, IP Triple Play,

ork module has also

ork.

The XE1 also has a full

y

Key Features

• 1 x 10 GbE GbE Wirespeed ports for Uplinks

• XFP Optics

• Support for EPSRTM50ms Resiliency

• Hardened for OSP designs

QoS

•

Eight Queues

• Strict Priority scheduling

• VLAN Stacking

Security

•

Upstream Forwarding Only

• Extensive ACL Suport

Services Supported

•

High Speed Internet

• VoIP

• IPTV

• Business

• Network Element Subtending

VPN

Allied Telesis’ iMAP family of integrated
Multiservice Access Platforms

Allied Telesis www.alliedtelesis.com

XE1 | AT-TN308-A 10 Gigabit Ethernet Network Module

Interface Specifications

Number of 10 GbE connections: 1
Backplane capacity: 2 x 10 Gbps
Physical design: Front Access

Port Specifications

Number of VLANs per port: 4095
Priority queues: 8
Dropped packet counter
Full traffic classifier support
Full traffic classifier action support

Protocols and Specifications

IEEE 802.1Q VLAN Bridging
IEEE 802.1p Traffic Class Expediting
IETF RFC 1112 IP Multicasting/IGMP Snooping v1
IETF RFC 2236 IP Multicasting/IGMP Snooping v2
DHCP Relay Agent option 82 (RFC 3046)
IEEE 802.1d,w Rapid Spanning Tree
IEEE 802.1q MEV (Double Tagging)
IETF RFC 3619 EAPS w/ATI Extensions for EPSR
IETF RFC 2131 DHCP
IETF RFC 1350 TFTP

Power Requirements

Maximum Power : 53W

Environmental Specifications

Operating Temp: -40C to 65C
Storage Temp: -40C to 75C
Relative Humidity: 5% to 95%, non-condensing

Regulatory Approvals

FCC Part 15 Class A/ANSI C63.4
EN 300 386 V1.3.1:2001-09/EN 55022:1998, Class A
VCCI Class A; ITE/ CISPR 22:1997 Class A
EN 300 386 V1.3.1:2001-09/EN 55022:1998, Class A
EN 300 386 V1.3.1:2001-09/EN 61000-4-3:1998
EN 300 386 V1.3.1:2001-09/EN 6100-4-6:1996
EN 300 386 V1.3.1:2001-09/EN 61000-4-4:1995
EN 300 386 V1.3.1:2001-09/EN 61000-4-5:1995
EN 300 386 V1.3.1:2001-09/EN 61000-4-2:1999
UL/cUL 60950: IEC60950
NEBS Level 3,

A RUS

USD

GR-1089 Issue 3,

GR63 Issue 2

Ordering Information

XE1

Model Description Part #

XE1 1x 10 GbE WAN interface card AT-TN-308-A

iMAP 9x00 Chassis

Model Description Part #

iMAP 9700 17-slot Chassis Group w/o filler plates AT-TN-250G-B

iMAP 9400 7-slot Chassis Group w/o filler plates AT-TN-251G

Supported iMAP Line Cards and Accessories

Model Description Part #

FE10 10-port, 100Mbps Fast Ethernet Service Module AT-TN-102-A

FX10FX 10-port, 100Mbps MultiMode Fiber Service Module AT-TN-104-A

FX10LX 10-port, 100Mbps SingleMode Fiber Service Module AT-TN-107-A

FX10BX 10-port, 100Mbps SM, single fiber Service Module AT-TN-109-A

vice Module

POTS24 24-port, PO

TS Ser

AT-TN-113-A

GE8 8-port, Gigabit Ethernet Service Module AT-TN-117-A

EPON2 2-port, GEPON Service Module AT-TN-118-A

CES8 8-port, T1/E1 Circuit Emulation Service Module AT-TN-119-A

ADSL24A 24-port,

ADSL2+

Annex A Ser

vice Module

AT-TN-121-A

PAC24 24-port, POTS/ADSL2+ Annex A Combo AT-TN-123-B

ADSL24B 24-port, ADSL2+ Annex B Service Module AT-TN-124-B

NTE8 8-port, MLPPP T1/E1 Service Module AT-TN-125-A

SHDSL24 24-port, SHDSL Ser

vice Module

AT-TN-127-A

VDSL24B 24-port, VDSL2 Service Module (AnnexB) AT-TN-128-A

ADSL24SA 24-port, ADSL2+ with splitters Service Module AT-TN-129-A

VDSL24A 24-por

VDSL2 Ser

t,

vice Module (Anne

xA)

-TN-130-A

T

A

ADSL48A 48-port, ADSL2+ Service Module (AnnexA) AT-TN-131-A

ADSL48B 48-port, ADSL2+ Service Module (AnnexB) AT-TN-132-A

PO

TS24EU

24-por

t PO

TS ser

vice module

, EU harmonized impedance

-TN-136-A

T

A

Suppor

ted iMAP Network Cards

Model Description Part #

AN interface card

GE3 3x GbE

USA Headquarters | 19800 North Creek Parkway | Suite 200 | Bothell | WA 98011 | USA | T: [phone] | F: [phone]
European Headquarters | Via Motta 24 | 6830 Chiasso | Switzerland | T: +41 91 69769.00 | F: +41 91 69769.11
Asia-Pacific Headquar

ters | 11 Tai Seng Link | Singapore | 534182 | T: [phone] | F: [phone]

W

-TN-301-A

T

A

www.alliedtelesis.com

© 2006 Allied Telesis Inc.All r ights reserved. Information in this document is subject to change without notice. All company names, logos, and product designs that are trademarks or registered trademarks are the property of their respective owner s. 617-000188 Rev.A