Allied Telesis AT-TN118-A 2 User Manual

Datasheet | integrated Multiservice Access Platform
EPON2
AT-TN118-A 2 Port EPON Service Module
FTTH Ov
er Any Last Mile
Infrastructure
As broadband deployments continue the gradual but inevitable migration to Fiber To The Home (FTTH), Allied Telesis is well positioned to support any FTTH infrastructure with the introduction of the EPON2 line interface module. This addition complements the existing line of active 100Mbps FTTX products available from Allied Telesis. As customer demand for IP enabled services increases, Service Pro must weigh the benefits of point-to-point versus point-to-multipoint deployments. The Allied Telesis iMAP is the onl platform that offers solutions for both scenarios eliminating the uncertainty of which last mile infrastructure to deploy.
Using the same approach to last mile design, the EPON2 service module is made with hardened components offering Service Providers of all kinds the added flexibility of CO or remote deployments. With standards based 1000BASE-PX20 U/D pluggable SFP
the EPON2 module provides optical
optics, reach of up to 20km using while supporting up to 32 subscr
eatures such as QoS, security and IP Video,
ey f
k the EPON2 module is a k IP Triple Play deployment relying on PON last mile infrastructures.
As IPTV services continue to reach out to residential communities, Service Providers using Allied Telesis’ iMAP and EPON2 solution can accommodate the most advanced
unications services available today.
comm Suppor
ting 16:1 or 32:1 splits, module can support PON bandwidth up to 1Gbps bidirectional. With powerful QoS traffic management, bandwidth guarantees and maximum bandwidth limits on a per subscriber, per service basis.
s per PON por
iber
AT-TN118 provides minimum
the
y IP access
Supporting
t.
ey component to any
the EPON2
vider
s
Contin
uing the IP Convergence
over PON
In choosing EPON IEEE 802.3ah standards based technology, Allied Telesis has enabled Service Providers with the ability to offer native IP-based services over either existing or new­build PON infrastructures. One of the inherent benefits of EPON versus other PON alternatives is the ability to transport all traffic in its native IP/Ethernet format. This protocol efficiency is vital to the IP convergence of all traffic - Voice,Video and Data. Should the need arise for RF overlay, the EPON2 LIF may accommodate such deployments in the future*.
As IP convergence continues in last mile access, Allied Telesis’ iMAP and EPON2 LIF are well poised to enable the transition while maintaining a cost effective point-to-multipoint optical last mile infrastructure. Since worldwide deployments of EPON have significantly outpaced other PON alternatives, Allied Telesis is able to leverage aggressive price points. When used with Allied Telesis’ intelligent
vice Gateways (iMG), the EPON2
Multiser enables seamless delivery of IP services to residential and small b
P
art of a IP Broadband Access
usiness customer
s.
Family
Whether it is broadband ADSL2+, FTTH or POTS, the iMAP family is the ideal platform for last mile service deliver y.The EPON2 line card can be used with any of the iMAP family of carrier grade, IP Multiservice Access Platforms:
iMAP 9700 (9RU, 17 service slots)
iMAP 9400 (3RU
iMAP 9100 (1RU
Min
Provisioning, management, and diagnostics of subscriber ports can be accomplished from either the iMAP command line interface or the NMS.
7 ser
,
vice slots)
3 ser
,
vice slots)
Key Features
2 PON ports
Support for 32 subscribers per PON
IEEE 802.3ah OAM
SFP optics – 20km support
Management of
192 VLANs per PON
Extensive ACL support
QoS
Eight queues
Per VLAN/Ser vice SLA
Per subscriber SLA
Min/max downstream/upstream BW
Guarantees
Strict/w
Security
C flooding –
MA
DHCP option 82 rela
Upstream forwarding only for all subscribers
vices Supported
Ser
High-speed Internet
oIP
V
IPTV
Gaming
Business
AT-iMG646MOD
eighted priority scheduling
VLAN-based
y/snooping
VP
*May require external hardware not currently available.
Allied Telesis www.alliedtelesis.com
EPON2 | AT-TN118-A 2 Port EPON Service Module
Interface Specifications
Number of PON ports: 2 Number of subscribers per PON: 32 Backplane capacity: 2Gbps Physical design: Front access
EPON Standards
IEEE 802.3ah EFM TM-2004 IEEE 802.3ah EFM PON clause 64 IEEE 802.3ah OAM clause 57 IEEE 802.3ah optics clause 60
Port Specifications
Priority queues per port: 8 RMON counters Traffic classifier support Traffic classifier action support User configurable per VLAN SLA
Protocols and Specifications
IEEE 802.1Q VLAN bridging IEEE 802.1p prioritization IETF RFC 1112 IP Multicasting/IGMP snooping v1 IETF RFC 2236 IP Multicasting/IGMP snooping v2 DHCP Relay Agent option 82 (RFC 3046)
Power Requirements
Maximum power: 25W
Environmental Specifications
Operating temp: -5ºC to 55ºC Storage temp: -40ºC to 75ºC Relative humidity: 5% to 95%, non-condensing
Regulatory Approvals
FCC Part 15 Class A/ANSI C63.4 EN 300 386 V1.3.1:2001-09/EN 55022:1998, Class A VCCI Class A; ITE/ CISPR 22:1997 Class A EN 300 386 V1.3.1:2001-09/EN 55022:1998, Class A EN 300 386 V1.3.1:2001-09/EN 61000-4-3:1998 EN 300 386 V1.3.1:2001-09/EN 6100-4-6:1996 EN 300 386 EN 300 386 V1.3.1:2001-09/EN 61000-4-5:1995 EN 300 386 V1.3.1:2001-09/EN 61000-4-2:1999 UL/cUL 60950: NEBS Level 3, GR-1089 Issue 3, GR63 Issue 2 USDA RUS
V1.3.1:2001-09/EN 61000-4-4:1995
IEC60950
SFP optics
Ordering Information
E
PON2
Model Description Part #
EPON2 2 ports, EPON service module AT-TN-118-A
iMAP 9x00 Chassis
Model Description Part #
iMAP 9700 17-slot chassis with DC power without faceplates AT-TN-250G-B
iMAP 9400 7-slot chassis with DC power without faceplates AT-TN-251G
MiniMAP 9101 3-slot mini chassis with DC power AT-TN-9101-A-80
MiniMAP 9102 3-slot mini chassis with AC power AT-TN-9102-A-xx*
iMAP Common Control
Model Description Part #
CFC24 24GbE switch controller card AT-TN-401-C
GE3 3 x GbE WAN interface card AT-TN-301-C
CFC12 12GbE switch controller card AT-TN-408-A
CFC56 56GbE switch controller card AT-TN-407-B
XE1 1 x 10GbE WAN interface card AT-TN-308-A
Related iMAP Accessories
Model Description Part #
EPON SFP SFP BiDi, 20km, burst AT-SPBD20B-14
Filler Full size service slot filler plate AT-TN-M000-A
Related EPON CPE
Model Description Part #
Please see
EPON ONU Outdoor ONU suppor
Voice, Video, Data
ting
-iMG646MOD
T
A datasheet
*
Where XX = 10 for U.S. power cord
Allied Telesis’ iMAP family of
Access Platforms
ated Multiser
integr
USA Headquarters | 19800 North Creek Parkway | Suite 100 | Bothell | WA 98011 | USA | T: +1 800 424 4284 | F: +1 425 481 3895 European Headquarters | Via Motta 24 | 6830 Chiasso | Switzerland | T: +41 91 69769.00 | F: +41 91 69769.11 Asia-Pacific Headquar
vice
ters | 11 Tai Seng Link | Singapore | 534182 | T: +65 6383 3832 | F: +65 6383 3830
30 for U.K. power cord
40 for Australian power cord 50 for European power cord
www.alliedtelesis.com
© 2008 Allied Telesis Inc.All r ights reserved. Information in this document is subject to change without notice. All company names, logos,and product designs that are tr ademarks or registered trademarks are the proper ty of their respective owners. 617-000113 Rev. D
Loading...