Page 1
AT-S101 Version 1.3.0
Management Software for the
AT-GS950/8POE Gigabit Ethernet WebSmart Switch
Software Release Notes
Please read this document before you begin to use the management software.
Supported Platforms
The AT-S101 Version 1.3.0 is supported on the AT-GS950/8POE Gigabit Ethernet WebSmart
switch.
Product Documentation
For the AT950/8POE documentation, refer to the following guides:
AT-GS950/8POE Gigabit Ethernet WebSmart Switch Installation Guide AT-S101
Management Software User’s Guide
Both documents are available from the Allied Telesis web site at www.alliedtelesis.com.
What’s New in Version 1.3.0
New Features
None
Operational Notes
The following issue was found in this release:
SFP 100 - Switch over to fiber fails after fiber link is restored. It happens when an AT-SPFX/2
100M SFP transceiver is used when a backup copper link is 1G. Recommended User
Workaround: Works fine when the fiber and copper speeds are similar. There are no issues
with different SFP models.
Resolved Issue
The IP address can now contain a 255 word within it. Previously, an error message was
displayed and an address containing a 255 word was not accepted.
PN 613-001604 Rev A 1
Page 2
AT-S101 Version 1.3.0 Software Release Notes
Features History
Version 1.2.0 Software Features
The SNTP (Simple Network Time Protocol) feature has been added.
Version 1.1.0 Software Features
Management access can now be restricted to the default VLAN (VLAN 1). This feature is
activated when you select ENABLE for the Management VLAN field on the Tagged VLAN
management web page. If this field is set to DISABLED, the management access is available
on any VLAN. See the illustration below for the location of this feature.
Version 1.0.0 Software Features
The AT-S101 Version 1.0.0 Management Software supports the following features:
Web-based interface
Dynamic Host Configuration Protocol (DHCP)
Port-based and tagged VLANs
Quality of Service (QoS) support
Port trunking supporting static and LACP (Link Aggregation Control Protocol) port trunks
Port mirroring
Spanning Tree (STP) and Rapid Spanning Tree (RSTP)
IGMP Snooping supporting IGMP versions 1 and 2
Simple Network Management Protocol (SNMP) versions SNMPv1 and SNMPv2c
Bandwidth Control
MAC address table with a storage capacity of 8,000 entries
Static multicast addresses
802.1x Port-based Network Access Control (IEEE 802.1x)
Remote Authentication Dial In User Services (RADIUS) client
PN 613-001604 Rev A 2 Allied Telesis, Inc.
Page 3
AT-S101 Version 1.3.0 Software Release Notes
Destination MAC Filter
User-defined Power over Ethernet (PoE) on four PoE ports
Classifiers to help define Access Control Policies (ACP)
TFTP and HTTP to upgrade the firmware image
Traffic, error, and history statistics
Version 1.0.0 Hardware Features
The AT-GS950/8POE switch has the following features:
Eight 10/100/1000Base-T auto-sensing, auto-MDIX switch ports with PoE available on ports
1 through 4
Two Gigabit Ethernet small form-factor pluggable (SFP) transceiver slots for combo ports that
support 100/1000Mbps
PoE feature conforms to IEEE802.3af Data Terminal Equipment (DTE)
Supports back pressure flow control at half-duplex and IEEE802.3x at full-duplex
Head of Line (HOL) blocking prevention
Web management with a pre-assigned IP address of 192.168.1.1
Status LEDs for ports, transceiver slots, and system
19-inch rack mountable
Internal power supply
Fanless design
PN 613-001604 Rev A 3 Allied Telesis, Inc.
Page 4
AT-S101 Version 1.3.0 Software Release Notes
Contacting Allied Telesis
This section provides Allied Telesis contact information for technical support as well as sales or
corporate information.
Online Support
You can request technical support online by accessing the Allied Telesis Knowledge Base at
www.alliedtelesis.com/supportcenter. You can use the Knowledge Base to submit questions
to our technical support staff and review answers to previously asked questions.
Email and Telephone Support
For Technical Support via email or telephone, refer to the Support & Services section of the
Allied Telesis web site: www.alliedtelesis.com/support. Select your country from the list
displayed on the website. then select the appropriate menu tab.
Warranty
For hardware warranty information, refer to the Allied Telesis web site at
www.alliedtelesis.com/support/warranty.
Returning Products
Products for return or repair must first be assigned a return materials authorization (RMA)
number. A product sent to Allied Telesis without an RMA number will be returned to the sender at
the sender’s expense.
To obtain an RMA number, contact the Allied Telesis Technical Support group at our web site:
www.alliedtelesis.com/support/rma. Select your country from the list displayed on the website.
Then select the appropriate menu tab.
Sales or Corporate Information
You can contact Allied Telesis for sales or corporate information through our web site:
www.alliedtelesis.com/purchase/direct.
To find an office near you, select www.alliedtelesis.com/office.
Management Software Updates
New releases of management software for our managed products are available on our Allied
Telesis web site at http://www.alliedtelesis.com/support/software.
Copyright © 2010 Allied Telesis, Inc.
All rights reserved. No part of this publication may be reproduced without prior written permission
from Allied Telesis, Inc.
Allied Telesis and the Allied Telesis logo are trademarks of Allied Telesis, Incorporated. All other
product names, company names, logos or other designations mentioned herein are trademarks
or registered trademarks of their respective owners.
PN 613-001604 Rev A 4 Allied Telesis, Inc.
Loading...